Elektron Tonverk handleiding
Handleiding
Je bekijkt pagina 47 van 110
11. THE TRACK SETUP MENU
47
11.1.5 LOOP MODE
Sets the behavior Single Player machine’s loop mode when PLAY MODE is set to FORWARD LOOP or
REVERSE LOOP. This setting is not availble for the Multi Player and Subtracks machines.
SUST. Sustain makes the sample loop for as long as the envelope is in the sustain phase. Once in the
release phase, the sample plays to the end and then stops.
CONT. Continuous makes the sample loop through both the envelope’s sustain and release phases.
11.1.6 OCTAVE
Sets the base octave of the preset. It also makes preset locking more practical since you can control the
octave setting on the preset and minimize the need to transpose the sequencer notes to make two or
more presets work together. This setting is not availble for the Subtracks machine.
11.1.7 PITCH BEND DEPTH
Sets the amount of pitch bend data from external MIDI devices that aects Tonverk.
11.1.8 PITCH BEND
Opens a menu where you can assign up to four parameters to the MIDI pitch bend command. Press
[YES] to open the menu. You can select parameters from the SRC, FLTR, AMP, FX, and MOD PARAM-
ETER pages. Turn the DATA ENTRY knobs A–D to select the track parameters that you wish to assign.
Press [YES] to confirm the selection. Then use DATA ENTRY knobs E–H to set the modulation depth of
the four track parameters. The depth is an oset of the original track parameter value.
Turn LEVEL/DATA to test your settings.
11.1.9 AFTERTOUCH
Opens a menu where you can assign up to four parameters to the MIDI aftertouch command. Press
[YES] to open the menu. Selecting parameters and setting modulation depth work in the same way as
for PITCH BEND.
11.1.10 MODULATION WHEEL
Opens a menu where you can assign up to four parameters to the MIDI mod wheel command (CC #1).
Press [YES] to open the menu. Selecting parameters and setting modulation depth work in the same
way as for PITCH BEND.
11.1.11 BREATH CONTROLLER
Opens a menu where you can assign up to four parameters to the MIDI breath controller command (CC
#2). Press [YES] to open the menu. Selecting parameters and setting modulation depth work in the same
way as for PITCH BEND.
11.2 SRC
Here you can select the SRC machine. Use [UP]/[DOWN] to select machine, and then press [YES] to
assign the selected machine to the track. From this page, you can also access and choose the two insert
FX machines for the track. Use [LEFT]/[RIGHT] to navigate to the desired machine category. For more
information, please see “A.2 SRC MACHINES” on page 79. Press [FUNC] + [SRC] to directly access this
page. There are no SRC machines available for SEND FX and MIX tracks.
Bekijk gratis de handleiding van Elektron Tonverk, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elektron |
| Model | Tonverk |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15555 MB |