Electrolux EED-625 handleiding
Handleiding
Je bekijkt pagina 26 van 52
26
Installation manual
5 Water connection
All water intake connections to the machine should be fitted with manual shut-off valves and filters, to facilitate instal-
lation and servicing.
Water pipes and hoses should be flushed clean before installation.
The machine shall be connected with new water hoses. Re-used water hoses must not be used.
Hoses are to be of an approved type and grade and comply with national regulations.
After installation hoses must hang in gentle arcs.
All connectors present on the machine must be connected to the water supply or the machine may not func-
tion properly. The table shows the possible connection options, which will depend on the water types to be con-
nected to the machine. Information is also available on the panel above the connections.
Note!
The water supply should be within the recommended hardness range of 3 grains or less per gallon. Higher
hardness may cause excessive formation of limescale. Chlorides must not exceed 30 ppm. The buildup of
limescale will negatively affect operation, performance and warranty approval.
Water type Water connection
1
2
EED-618, EED-620, EED-625, EED-630
• Cold and hot
EED-618, EED-620, EED-625, EED-630
1. Cold
2. Hot
1
2
3
EED-645, EED-665, EED-685
• Cold and hot
EED-645, EED-665, EED-685
1. Cold
2. Hot
3. Cold (for detergent container) / Hot
Bekijk gratis de handleiding van Electrolux EED-625, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EED-625 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4390 MB |
