Electrolux EDSH4944SS handleiding
Handleiding
Je bekijkt pagina 22 van 28
22
Factors affecting
performance
Water Pressure
The hot water line to dishwasher must provide
water pressure between 20 and 120 psi.
Low water pressure may occur when
laundry or showers are in operation. If you
experience poor wash performance you
may need to wait until water use is reduced
before starting dishwasher.
Water temperature
Hot water is needed for best dish washing
and drying results. Water entering
dishwasher should be at least 120°F
(49°C) to give satisfactory results.
To check water temperature entering
dishwasher:
• Turn on hot water faucet nearest
dishwasher for several minutes to clear
cool water from pipes.
• Hold a candy or meat thermometer
in the water stream to check the
temperature.
• If temperature is below 120°F (49°C),
have a qualified person raise the hot
water heater thermostat setting.
Power Alert
The dishwasher stops temporarily if a period
of abnormal voltage occurs while the
dishwasher is running.
NOTE
Before starting a cycle, run hot water to
clear cool water from pipes.
NOTE
A power abnormality is when the voltage
is either too low or too high to properly
run appliances or electronic devices.
A power outage is when no power is
available to run any electronic devices.
NOTE
The buttons on the control panel may be
disabled when voltage is too low for the
dishwasher to operate.
Once the voltage returns to normal, the
dishwasher automatically resumes the wash
cycle if the door has not been opened. If the
door is opened during the abnormal power
condition, press start and close the door
within 4 second for the cycle to resume when
power returns to normal.
The red power indicator in the status window
turns off once power is returned to normal.
If power becomes abnormal during cycle
selection, the START LED will go out and
the status window displays the red “power”
message and 2 dashes.
TROUBLESHOOTING
During this time the UI will display 2 dashes
and a red “power” message with a lit START
LED.
Resume the wash after power
outage
When power is restored, the control panel
lights up for 3 seconds while the dishwasher
starts up. After start-up completes, the wash
settings of where the cycle left off display
on the control panel and status window.
The red “power” message will display in the
status window and the START LED blinks to
indicate power was out. The control panel
stays in this state until any button other than
CANCEL is pressed. Pressing CANCEL will
cancel the cycle.
To resume a wash cycle after a power
outage, open the door to show where the
wash settings left off. Press START to resume
the wash cycle.
Bekijk gratis de handleiding van Electrolux EDSH4944SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EDSH4944SS |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 3221 MB |
