Electro-Voice Evolve 90 handleiding
Handleiding
Je bekijkt pagina 28 van 64
28 en | Input & Mixer operation EVOLVE 70/90 Portable Column Loudspeaker
2025-03 | 01 |
User manual
Bosch Security Systems, LLC
8 Input & Mixer operation
8.1 INPUT DSP control menu
The loudspeaker INPUT DSP control menu selections are available for the EVOLVE powered
loudspeakers.
Refer to INPUT list, page 52 for the complete menu list.
To control the mixer channels:
1. Press the input selection soft key to select the input channel.
The softkey will illuminate once selected.
2. Use the MASTER VOLUME knob to adjust the level.
3. Press the MASTER VOLUME knob to enter the input channel's DSP control menu.
4. Press the input selection soft key again to deselect the input channel for control.
The soft key will no longer be illuminated.
INPUT control adjustments
Caution is advised when adjusting the INPUTLEVEL and EQ. Usually minor changes are
sufficient to produce the best results in the overall sound.
To adjust the incoming sound:
– Set all EQ controls to 0dB or FLAT.
– Avoid setting the EQ controls to extreme positions.
– Use natural reproduction as a starting point.
– Rely on your musically trained ear.
INPUT LEVEL control
The INPUT LEVEL control adjusts the sensitivity of the incoming signals to the internal
operation level of the mixer.
To achieve a good signal input level:
1. Set the volume (VOL) to MUTE using the MASTER VOLUME knob.
2. Press the input selection soft key and use the MASTER VOLUME knob to set the INPUT
LEVEL to MUTE.
3. Connect the sound source (microphone, instrument, etc) to the selected input.
4. Start the sound source at the highest volume level to be expected. Sing or speak as
loudly as possible directly (close up) into the microphone.
5. While playing the sound source or singing into the microphone:
– Increase the INPUTLEVEL by selecting the input channel using the input selection
soft key and using the MASTER VOLUME knob, so that during the loudest part, the
PEAK does not show. Press the input selection soft key again to deselect the input
channel.
– Increase the MASTER VOLUME until you get the required output from the
loudspeaker. This is the basic channel setting.
If further adjustments to the EQ setting of the channel are necessary, perform these steps
again. Changes in the sound shaping section also have an influence on the overall level of
the channel.
Bekijk gratis de handleiding van Electro-Voice Evolve 90, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electro-Voice |
| Model | Evolve 90 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5266 MB |
