Handleiding
Je bekijkt pagina 7 van 12
7
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM
MUST BE PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-
CLOCKWISE TO THE PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE
ATTEMPTING IGNITION.
GAS REQUIREMENTS
• The pressure adjuster should comply with the standard EN16129 and current regulations in the
country where it is installed, which may be found at your nearest retailer of gas items.
• Refer to the technical date. It is strictly prohibited to use adjustable pressure.
• The life expectancy of the regulator is estimated as 10 years. It is recommended that the regulator is
changed within 10 years of the date of manufacture or the national conditions require it.
• The type of replaceable hose should meet the standard of EN16436-1.
• The length of the hose must be 0.4 meters (minimum) and 1.0 meters (maximum). Worn or damaged
hose must be replaced. Ensure that the hose is not obstructed nor kinked. It is recommended that
the hose is changed within 1 year of the date of manufacture or the national conditions require it.
• Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or rusty gas tank
may be hazardous and should be checked out by a gas supplier.
• Always perform a leak test on gas connections whenever a cylinder is connected. If bubbles form in
the leak test solution, do not use. Never use a flame to test for leaks.
• Never connect this appliance to an unregulated gas source.
• Use only regulator and hose approved for LP Gas at the correct pressures and gas type.
• Using 30mbar butane regulator for butane of I3B/P(30) or butane of I3+.
• Using 30mbar propane regulator for propane or butane/propane mixture of I3B/P(30).
• Using 37mbar propane regulator for propane of I3P(37).
• Using 50mbar butane regulator for butane of I3B/P (50).
• Using 50mbar propane regulator for propane or butane/propane mixture of I3B/P (50)
CONNECTING TO A GAS CYLINDER
• Use max 13kg gas cylinder. Please refer to your gas supplier for suitable gas
cylinder.
• Refer to your gas supplier for instructions on the use of your gas cylinder.
• Only change gas cylinders outdoors or in a well-ventilated area away from
naked flames and any other source of ignition.
• The gas cylinder must always be used in an upright position.
• Close the appliance control dial by turning fully clockwise.
• Close the gas cylinder tap and then attach the regulator onto the gas cylinder.
• Tighten all connections firmly and with a spanner where appropriate. The
cylinder should be located on the cylinder base.
• Check for leaks at all joints using soapy water. If a leak is found, tighten the
joint and then re-test.
Bekijk gratis de handleiding van ElectriQ EQODHGS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | EQODHGS |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 949 MB |
