Handleiding
Je bekijkt pagina 8 van 25
Page 8 of 25
WALL MOUNTING
The heater must be installed at least 15cm from the floor and 50cm from the ceiling.
IMPORTANT: Before drilling, ensure that no wires or pipelines are behind the wall to prevent
damage.
1. Fix two brackets onto the bottom of the unit as shown in the image below using the
screws provided (ᶲ4x12).
2. Measure the distance between the wall hanging holes
on the rear of the heater to confirm they are 530 mm
apart.
3. After double-checking the measurements mark the position of the upper brackets on the
wall, using a pencil (following the diagram above for spacing). We would advise using a
spirit level to ensure the markings are square and level.
4. Once you are happy with the position of the marks, drill 8mm diameter holes using a
suitable drill bit.
5. Insert the wall plugs into the holes. Please note depending on the wall type; alternative
fixings may be required. Ask for professional advice if unsure.
6. Fix the brackets to the wall using 6 screws (ᶲ4x35)
7. Hang the heater onto the wall brackets using the two holes at the back of the heater,
ensuring it is secure, before gently resting the base of the unit against the wall so that
the brackets sit flush.
.
.
Bekijk gratis de handleiding van ElectriQ EGH25AW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | EGH25AW |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2208 MB |
