Handleiding
Je bekijkt pagina 12 van 14
Page 12 of 14
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS
The appliance is supplied with a set of honeycomb cooling/filter pads. The cleaning frequency
for the honeycomb filters depends on local air and water conditions. In areas where the
mineral content of the water is high (hard water), mineral deposits may build up on the
honeycomb filter and restrict airflow. If mineral deposits remain on the honeycomb pads, the
filter should be removed and washed under fresh water. We recommend cleaning the
honeycomb filter at least every two months, depending on your needs.
For best results, allow the honeycomb filter to dry after each use by turning off the cooling
function for 15 minutes (with an empty water tank) before turning the unit off.
Unplug the power cord, then Twist the lugs holding the filter frames to the unit and lift off the
filters.
Lift the rear honeycomb filter away from the unit. Remove the side honeycomb filters
following the same method. Scrub the honeycomb filter with a mild detergent and a soft
brush, clean with water, and dry. Do not dip in water.
Replacement filters can be purchased for this unit under model: Arctic55ER-honeycomb
END-OF-SEASON MAINTENANCE
1. Empty the tank and wipe it with warm soapy water.
2. Dry the tank and clean the Honeycomb pads
3. Store any Icepack you may use in the water tank
4. Cover the unit and keep it in a dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit yourself. Unauthorised repair attempts will invalidate
the warranty and may cause bodily harm.
ISSUE
POSSIBLE CAUSE
SUGGESTED SOLUTION
No power or
display is off
• Power cord not plugged in or
poor contact
• No power from socket
• Honeycomb filter support not
installed correctly
• Power button not pressed
• Circuit board fault
• Ensure the power cord is securely
connected
• Test the socket with another appliance
• Reinstall the honeycomb filter correctly
• Press the power button
• Contact customer support
Display LED
not working
• LED screen is damaged
• Replace the LED screen
No air
output or
weak airflow
• Fan blades stuck
• Filter is blocked
• Fan blade loose or not fixed
• Control panel error
• Inspect and clear obstructions from fan
blades
• Clean or replace the filter
• Reinstall or replace the fan blade
• Contact the service to inspect the
control panel
Motor not
responding
or out of
control
• Faulty control panel button
• Loose wiring between motor
and control board
• Replace the control panel
• Check and reconnect wiring securely
Bekijk gratis de handleiding van ElectriQ Arctic55ER, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | Arctic55ER |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2443 MB |
