Elation PP-DMX20L handleiding

Verlichting

Elation

4 pagina's

PDF beschikbaar

Handleiding

1 32

8888

CH:01 CH:04

A:001 A:512

P:01 P:16

SP:01 SP :99

Functions and Controls Front Panel: Functions and Controls Rear Panel:

POWER

DMX IN DMX OUT

POWER

INDICATOR

F6.3A 250V 5x20 mm

2 3

POWER INPUT

AC 120V ~ 60Hz,

20A MAX

CAUTION: RISK OF ELECTRICAL SHOCK. DO NOT OPEN

N’OUVREZ PAS..RISQUE DE CHOCELECTRIQUE

WARNING: THIS APPARATUS MUST ME EARTHED.

1=Ground

2=Data-

3=Data+

7 1110 8 9

7. Channel Fuses - Each of the four channels is protected by a 6.3A

fuse. These fuses prevent you from overloading and damaging

your pack. Be sure to always replace with the exact same type

fuse.

8. Power Switch - This switch controls the units main power.

9. Power Indicator - This LED indicates the unit is active.

10.DMX Input - This connector accepts your DMX input signal.

11.DMX Output - This connector sends your DMX input signal

through to the next DMX device.

1. Down Button - This button will decrease the displayed value in the

LCD display.

2. MODE Button - This button will activate the different functions in

DMX and chase modes.

3. Up Button - This button will increase the displayed value in the

LCD display.

4. LCD Display - This multifunction display will detail all chase and

program activity that pertains to the current operating mode of the

pack.

5. GREEN L.E.D. Indicators - These LEDs will indicate their relevant

channel activity.

6. POWER OUTPUT - 3-prong grounded Edison output sockets. 8

total output sockets. Each channel has an output maxiimum of 6

amps. The unit has an output maximum of 15 amps

Operation Modes:

The PP-DMX20L

™

has two different operating modes. This unit can

be used as a four channel chaser or as a 1, 2, or 4 channel DMX power

pack. Please follow the instructions below to operate the unit in your

desired mode.

Chase Mode:

Use this operating mode only if you are planning on using your PP-

DMX20L

™

as a four channel chaser. This device has 16 built in pro

grams, you may select any of these programs to run at one time. You

may control the speed at which the programs will chase.

1. Connect your lighting effects to the any of the eight power sock-

ets on the pack.

2. Use the mode button to select chase mode. Chase mode is

indicated by "PA" followed by numbers 01-16. "PA" is Pro-

grammed Applied. If "A" appears in the LCD display you are in

DMX mode, the "A" stands for address.

©Elation Professional® - www.elationlighting.com - PP-DMX20L Instruction Manual Page 6©Elation Professional® - www.elationlighting.com - PP-DMX20L Instruction Manual Page 5

Figure 5

Bekijk gratis de handleiding van Elation PP-DMX20L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.