Elation JOY300 handleiding
Handleiding
Je bekijkt pagina 14 van 19
(V1.23) 14
5 Programming the
J
J
O
O
Y
Y
-
-
3
3
0
0
0
0
You can program the
J
J
O
O
Y
Y
-
-
3
3
0
0
0
0 in a standalone program within 25 steps. This program can
run automatically after turning on the unit. This means you need a DMX Controller for
programming but not for running the stand alone program.
5.1 Engage the Program Mode
Normal - Mode: Receive standard DMX signal.
Receive - Mode: The scanner receives DMX signals for programming and stores
the steps.
Send - Mode: The scanner works stand alone and sends DMX signals to other
scans.
a) Engage at the
J
J
O
O
Y
Y
-
-
3
3
0
0
0
0
Press the Menu key once. P_n_. You are now in the Normal – Mode.
Change with the Cursor key to the Receive – Mode P._r_ or further to the Send –
Mode P._S_
Press the Menu key again to confirm the changes.
b) Engage with a DMX Controller
Look at the channel selection overview table.
5.2 Write a program
You must be in the Receive- or Send – Mode to program the
J
J
O
O
Y
Y
-
-
3
3
0
0
0
0
.
. In this mode
the DMX Channels 13, 14 and 15 are activated.
Procedure:
1) Activate the Receive- or Send - Mode.
2) Set Channel No.13 to
“Set DMX-Values”
(DMX 16..254).
3) Choose the program step with DMX Channel No.15.
4) Set your DMX adjustments with the DMX Channels No.1..12.
5) Choose the Next Time or the Audio control with DMX Channel No.14.
6) Save the step with DMX Channel No.13 xx àà 255 àà 00.
Bekijk gratis de handleiding van Elation JOY300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | JOY300 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 2434 MB |
