EK Water Blocks EK-Quantum Reflection² 7000D D5 PWM D-RGB handleiding
Handleiding
Je bekijkt pagina 12 van 14
- 12 -
CONNECTING THE D-RGB LED STRIP
Plug the 3-pin connector of the distribution plate D-RGB LED light
to the D-RGB HEADER on the motherboard. The LED will work if the
pin layout on the header is as follows: +5V, Digital, Empty, Ground.
D-RGB Header
RGB Header
CONNECTING THE PUMP
The EK-D5 PWM pump has two connectors.
1. SATA Connector: It must be connected directly to your PSU at all
times as it is used to power the pump.
2. 4-pin PWM fan: It can be connected to your motherboard’s
CPU_ Fan or designated water pump header. It can also be
connected to a controller. This cable is used to control and report
the rotational speed of the pump. If it’s not connected, the pump
will run at maximum speed (100% PWM).
SATA
CONNECTOR
4-PIN PWM FAN
CONNECTOR
Bekijk gratis de handleiding van EK Water Blocks EK-Quantum Reflection² 7000D D5 PWM D-RGB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EK Water Blocks |
| Model | EK-Quantum Reflection² 7000D D5 PWM D-RGB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 943 MB |
