Einhell GP-HC 18/5020 Li T BL handleiding

Niet gecategoriseerd

Einhell

189 pagina's

PDF beschikbaar

Handleiding

Je bekijkt pagina 19 van 189

- 19 -

notice that the performance of the device drops.

Never allow the battery pack to become fully di-

scharged. This will cause it to develop a defect.

5.10 Battery capacity indicator (Fig. 16a)

Press the button for the battery capacity indicator

(A). The battery capacity indicator (B) shows the

charge status of the battery using 3 LEDs.

All 3 LEDs are lit:

The battery is fully charged.

2 or 1 LED(s) are lit:

The battery has an adequate remaining charge.

1 LED ﬂ ashes:

The battery is empty, recharge the battery.

All LEDs blink:

The battery temperature is too low. Remove the

battery from the equipment, keep it at room tem-

perature for one day. If the fault reoccurs, this me-

ans that the rechargeable battery has undergone

exhaustive discharge and is defective. Remove

the battery from the equipment. Never use or

charge a defective battery.

6. Operation

Please note that the statutory regulations gover-

ning noise abatement may diﬀ er from one loca-

tion to another.

Caution! Always use the shoulder strap when

working with the equipment. Always switch oﬀ the

equipment before you take oﬀ the shoulder strap.

Otherwise there is a risk of injury.

Put on the shoulder strap as described above, ﬁ t

the required mounting kit and adjust the equip-

ment to suit your needs.

Switching on/oﬀ

Switching on

•

Hold the equipment by the handles with both

hands (thumbs under the additional handle).

•

Slide the safety lock-off (Fig. 3/Item 4) to the

front and hold.

•

Switch on the equipment with the On/Off

switch (Fig. 3/Item 3). You can then release

the safety lock-off.

Switching oﬀ

Release the On/Oﬀ switch (Fig. 3/Item 3).

7. Working with the hedge trimmer

mounting kit

•

Check that the cutters work properly. The

twin-bladed cutters rotate in opposite direc-

tions, thus guaranteeing high cutting perfor-

mance and smooth operation.

•

Take care to maintain a steady foothold and

hold the equipment firmly in both hands away

from your body. Before you switch on, make

sure that the equipment is not touching any

objects.

Work practice

•

A hedge trimmer can be used to cut shrubs

and bushes as well as hedges.

•

To obtain the best cutting results, hold the

hedge trimmer so that the cutter teeth are

at an angle of approx. 15° in relation to the

hedge (see Fig. 17).

•

The twin-bladed cutters rotate in opposite

directions, thus enabling cutting in both direc-

tions (see Fig. 18).

•

It is recommended to tie a guide line of string

or the like along the hedge so that you cut the

hedge to a level height. Cut off all branches

which protrude beyond the guide line (see

Fig. 19/20).

•

Cut the sides of the hedge with curve-shaped

movements from the bottom up (see Fig. 21).

8. Cleaning, maintenance and

ordering of spare parts

Danger!

Remove the battery pack before doing any

cleaning and maintenance work.

8.1 Cleaning

•

Keep the handles free of grease so that you

can maintain a firm grip.

•

Never immerse the equipment in water or

other liquids in order to clean it.

•

Use a brush to remove deposits from the sa-

fety guards.

•

Keep all safety devices, air vents and the

motor housing free of dirt and dust as far as

possible. Wipe the equipment with a clean

cloth or blow it with compressed air at low

pressure.

Anl_GP_HH_18_50_Li_T_BL_SPK13.indb 19Anl_GP_HH_18_50_Li_T_BL_SPK13.indb 19 20.11.2024 14:22:2520.11.2024 14:22:25

Bekijk gratis de handleiding van Einhell GP-HC 18/5020 Li T BL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.