Eibenstock EPO 200-3 R NT handleiding
Handleiding
Je bekijkt pagina 18 van 64
18
Wet polishing:
The water connection is attached to the spigot of the protective cover.
Connect the machine to the water supply or a pressurised water container
via the GARDENA
Only operate the machine with clean water and a sufficient water supply.
The maximum water pressure should not exceed 3 bar!
The water supply must be regulated according to the material.
The dust/splash guard attached to the protective bonnet must
be adjusted to the height of the insert tools (discs) before
commissioning. To do this, place the appliance with the fitted insert tools on
a smooth surface and attach the protective strips to the protective cover
and removable segment using Velcro with a gap of approx. 1-3 mm to the
surface.
Switch on the appliance and carefully place it on the surface to be
processed. Hold the appliance firmly in both hands - one hand on the switch
handle and the second hand on the motor cap. Work in a linear or circular
motion. Work with light pressure. Excessive pressure increases abrasive
wear and worsens the sanding result.
A segment of the protective bonnet can be removed for work directly on
wall edges. This makes it possible to work on otherwise inaccessible areas.
To do this, pull the segment upwards from the protective cover.
Caution!
For all other sanding work, only work with the protective bonnet
completely closed.
Dust Extraction
Dust which occurs during your work is hazardous to health. That is why the
concrete grinder must be used with a vacuum cleaner, and a dust mask has
to be worn. The suitable Wet/Dry Vacuum Cleaner ESS 35 MP is available
as accessory. It can directly be attached to the connection on the dust
hood.
The suction hose can be locked against slipping out by means of the hose
fixing. Make the necessary drill hole as follows:
Put the suction hose in the connector of the hood.
Mark the plug-in depth with a crayon.
When insert the suction hose pull the ring of the hose fixing and turn the
nozzle till the fixation engages.
Drill 9 mm from this marking (line) a hole
with diameter 6 mm in the nozzle.
Bekijk gratis de handleiding van Eibenstock EPO 200-3 R NT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EPO 200-3 R NT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6520 MB |
