Eibenstock BST 90 handleiding
Handleiding
Je bekijkt pagina 18 van 23
17
Schräg bohren
▪ Loosen both Allen screws with the enclosed wrench .
Position the column in the appropriate angle
▪ Tighten both screws again.
At the beginning, drill very slowly, since the drill bit does only
starts cutting with a fraction of the cut surface in the material.
If you drill too fast or with too much pressure, the drill bit could
get jammed.
▪ Move the machine holder with the core drill upwards until it locks in the
final position.
▪ Remove the drill bit.
▪ Loosen the wing screw
▪ While doing so, hold the drill rig firmly!
▪ Remove the drill rig.
▪ Unscrew the quick action clamping screw
▪ Always keep the drill rig clean, especially the column with the toothing and
the 4 sliding pieces in the machine holder.
In order to allow the free movement of the pinion shaft, it should be slightly
lubricated.
▪ In order to achieve a good performance of the drill rig, the 4 sliding pieces
in the machine holder have to move along the column without slackness.
▪ After having drilled 10 holes you should check if the sliding pieces have got
loose-fitting due to drilling vibration.
Drilling
Demounting the Core Drill Unit
Care and Maintenance
Bekijk gratis de handleiding van Eibenstock BST 90, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | BST 90 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2841 MB |
