Eibenstock BST 250 handleiding
Handleiding
Je bekijkt pagina 17 van 76
17
Care and Maintenance
▪ Always keep the drill rig clean, especially the column with the toothing
and the 4 sliding pieces in the machine holder.
▪ In order to allow the free movement of the pinion shaft, it should be
slightly lubricated.
▪ In order to achieve a good performance of the drill rig, the 4 sliding
pieces in the machine holder have to move along the column without
slackness.
Attention:
After every tenth drilling you should check if the sliding pieces
have got loose-fitting due to drilling vibration.
If the position should have changed, it can be readjusted as follows:
▪ Using a 17 mm open-end wrench, loosen
the lock nut on the hexagon socket screw.
▪ Using an 8 mm hexagon key, adjust the
hexagon socket screws and thus the posi-
tion of the pressure pieces relative to the
column.
▪ Tighten the lock nut again and check that
the machine holder moves smoothly on
the guide column of the diamond drill
stand.
Warranty
In accordance with our General Terms and Conditions of Delivery, a war-
ranty period of 12 months applies to material defects in business transac-
tions with entrepreneurs (proof by invoice or delivery note).
This does not include damage resulting from natural wear and tear, exces-
sive use or improper handling. Damage resulting from material or manufac-
turing defects will be repaired free of charge by repair or replacement. Com-
plaints can only be accepted if the device is returned to the supplier or an
Eibenstock authorised repair shop in its unassembled state.
Bekijk gratis de handleiding van Eibenstock BST 250, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | BST 250 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11311 MB |
