EGO Power+ ST1624E-T handleiding
Handleiding
Je bekijkt pagina 11 van 20
56 VOLT LITHIUM-ION CORDLESS GRASS TRIMMER — ST1620E-T
11
SPECIFICATIONS
Voltage
56V
No-load Capital Speed
Low speed range:
3500-4800/min
High speed range:
4000-5500/min
Cutting Line Mechanism LINE-IQ FEEDING
Cutting Line Type 2.4 mm nylon twist line
Cutting Width 40 cm
Recommended Operating
Temperature
0°C-40°C
Recommended Storage
Temperature
-20°C-70°C
PACKING LIST
PART NAME QUANTITY
Grass trimmer 1
Bolt for Locking Shaft 1
Guard (with two screws preassembled
on the guard)
1
Quick Adjustable Front Handle
Assembly
1
Hex Wrench 1
Cutting Line 1
Shoulder Strap (AP1500) 1
Shoulder Strap Loop 1
Operator’s Manual 1
DESCRIPTION
KNOW YOUR GRASS TRIMMER ATTACHMENT (Fig. A)
1. Rear Handle
2. 2-speed Switch
3. Quick Adjustable Front Handle
4. Hinge
5. POWERLOAD
TM
Button
6. Guard
7. Speed Indicator
8. Height-Locking Clamp
9. Quick-release Lever
10. Hex Wrench
11. Trimmer Head (with LINE-IQ Feeding)
12. Release Tab
13. Cutting Line
14. Line-cutting Blade
15. Variable Speed Trigger
16. Lock-off Trigger
17. Latch
18. Electric Contacts
19. Ejection Mechanism
20. Shoulder Strap Loop
21. Shoulder Strap
ASSEMBLY
WARNING: If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this grass trimmer. Any such alteration or modification
is misuse and could result in a hazardous condition
leading to possibly serious personal injury.
WARNING: To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when assembling parts.
UNFOLDING THE SHAFT
WARNING: In order to avoid pinching your
hands or fingers, do not hold the shaft at the joint.
WARNING: Do not attempt to start the trimmer
until the shaft has been locked.
Put your grass trimmer on the ground or the floor and make
sure that the cable is inside the shaft, so that it will not be
pinched when closing the joints. Carefully unfold the shaft
until the two holes in the joint are accurately aligned (Fig. B).
Insert the bolt (supplied) and tighten it with the supplied hex
wrench to lock the shaft in place (Fig. C).
MOUNTING THE GUARD
WARNING: Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING: Never operate the tool without the
guard firmly in place. The guard must always be on
Bekijk gratis de handleiding van EGO Power+ ST1624E-T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EGO |
| Model | Power+ ST1624E-T |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1982 MB |
