Ecoteck Unica handleiding
Handleiding
Je bekijkt pagina 14 van 40
14
Use and maintenance manual - Model: “UNICA 10 V/C”
Select the language, using the keys that you
want to use as the display standard. Press the key
to conrm and go to the next screen.
To work correctly, the handheld device requires
interfacing with the electronic board inside the
product. For this reason, the display shows a rst
installation message.
If rst use of the handheld device, choose YES with
the selection keys .Press the key to conrm
and go to the next screen.
Follow the guide instructions to link via remote the
appliance to the display, as outlined in the gure
below.
Keep the remote communication key of the
electronic board pressed for a few seconds, placed
on the rear of the product, to start the unit search
procedure.
The yellow, ashing led, under the icon indicates
the electronic board is waiting to receive the
remote control signal.
Pressing the conrm key on the handheld
device, the components can communicate with
one another.
A tick sign on the display, accompanied by an
acoustic signal, indicates the remote connection
operation has successfully concluded.
If the batteries are replaced, you don’t necessarily
have to follow the initialisation procedure of the
handheld device. In this case, when the display
shows the message “FIRST INSTALLATION?”,
select NO and press the conrm key.
OK
OK
OK
OK
6.3 PELLET LOADING
Fuel is loaded by inserting pellets from the upper part
of the product, opening the door. Ensure the content
of the bag of pellets does not fall around the edges
of the tank, paying particular attention to centring,
during the loading phase. Also avoid the pellet
packaging coming in contact with hot surfaces.
Ensure you correctly close the cover of the tank again
after loading the pellets. Closure is controlled by an
electronic contact (for the models where planned).
In the event of non-closure, a sign warns the user to
pay attention to tightening, before passing to alarm
mode, in the event the warning is ignored.
6.2 EXTERNAL THERMOSTAT
If you want to manage the appliance from a
different room (in that specic room, the remote
handheld device cannot communicate), you can
connect an external thermostat to the product, to
allow modulation of combustion or, by activating
a particular function, allow switch on or off of the
product. As in the gure below, connect the terminals
of the thermostat to the terminal board on the back
of the product (near the emergency panel).
TERMINAL
EXTERNAL THERMOSTAT
Following electrical connection, to allow the
control unit to recognise the presence of the t.ext,
the recognition function must be enabled from
the SETTINGS menu (see the “ENABLE EXTERNAL
THERMOSTAT” paragraph)
By enabling the function that allows external
thermostat enabling, on the handheld device
reading and management of the ambient
temperature are inhibited. The handheld device
displays TON if required, TOFF if the temperature set
on T.ext is reached.
Bekijk gratis de handleiding van Ecoteck Unica, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecoteck |
| Model | Unica |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8886 MB |
