Ecoteck Libera handleiding
Handleiding
Je bekijkt pagina 17 van 48
Use and maintenance manual, model “LIBERA 8 V/C - LIBERA 11 V/C”
ENGLISH
17
5.4 SAFETY DISTANCES
L
B
F
R
U
Minimal distance from ammable
materials
R Right 300 mm
L Left 300 mm
B Back 100 mm
F Front side 900 mm
U Upper side 1000 mm
6 PRODUCT SETTINGS
Once installation instructions has been properly
carried out present, including external cladding
(where applicable) and electrical connection,
access the rear part of the product to power it.
A
EMERGENCY PANEL
B
The “I/O” switch - A in the gure above - must be
positioned on “I”. In the event of a power failure,
check the condition of the fuse placed in the
drawer under the switch - shown as B in the gure
above - (4A fuse, EU conguration). During periods
of non-use, it is advisable to disconnect the power
cable from the device and remove the batteries
from the remote control.
6.1 REMOTE CONTROL SETTINGS
Remove the battery cover on the back of the
remote control, as shown in gure C, and insert
3 batteries (1.5V alkaline AAA type) in the
compartment, paying attention to the polarity.
Close the battery cover as shown in gure D.
C
D
WARNING
Risk of
risk of explosion
if the battery is
replaced with the
wrong type.
Once used, batteries must be disposed of in the
appropriate collection centres.
To protect your batteries from adverse conditions
or misuse, remember the following:
• keep the remote control away from heat sources
(risk of explosion);
• in case of prolonged non-use of the remote
control, remove the batteries (risk of oxidation and
liquid leakage;
Nobis Srl declares that the remote control complies
with 2014/53/EU Directive.
The full text of the EU declaration of conformity is
available at the following Internet address:
https://www.nobisfire.it/wp-content/uploads/2019/04/DoC-
Palmare-Radio-Nobis-1.pdf
After inserting the batteries, the screen of the
remote control will briey show the Manufacturer's
logo, and then it will display the list of languages
available for the user interface: select your
language with the up and down arrow keys ↑↓
and press OK to conrm
In order to operate correctly, the remote control
needs to be connected via radio to the electronic
board of the product. For this reason, the display
will show the rst-installation message.
If you are using the remote control for the rst time,
choose YES with the arrow keys ↑ ↓. Press OK to
conrm and move to the next screen.
Bekijk gratis de handleiding van Ecoteck Libera, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecoteck |
| Model | Libera |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9584 MB |
