Ecler VEO-XTT44 handleiding
Handleiding
Je bekijkt pagina 8 van 20
8
6.2. Receiver Frontal and Rear Panel
1. Power LED: The LED illuminates red when power is applied.
2. ARC Mode: Pressing the button with paper clip or another pointed tool, the ARC
mode will be enabled and then the left LED will illuminate blue. Pressing it again,
the ARC mode will be disabled and the LED will be off.
3. ARC Audio In: Toslink connector to connect ARC audio source device (e.g.TV).
4. FW: Micro-USB port for firmware upgrade.
5. HDMI Out: Type-A female HDMI output port to connect HDMI display (e.g.TV).
6. Audio Breakout: If the ARC mode is OFF, the Toslink connector is connected to
speaker or amplifier for HDMI source audio de-embedding. Note that if the ARC
mode is ON, this port has no audio output.
7. IR In: 3.5mm jack to connect the IR receiver (not included) for IR pass-through.
8. IR Out: 3.5mm jack to connect the IR emitter (not included) for IR pass-through.
9. RS232: 3-pin terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled.
10. HDBT In: RJ45 port to connect the HDBT output port of transmitter by CATx
Ethernet cable. The LINK LED illuminates orange when there is a valid HDBaseT
link between the transmitter and the receiver. The HDCP LED illuminates green
when the video contains HDCP content.
11. DC 24V: DC connector for the power adapter connection.
1
2
3
4
5
6
7
8
9 11
10
Bekijk gratis de handleiding van Ecler VEO-XTT44, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTT44 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2400 MB |
