Ecler VEO-XTT44 handleiding
Handleiding
Je bekijkt pagina 10 van 20
10
7.1. User-defined EDID Setting
Except directly selecting the built-in EDID, the specific EDID can be customized by
following the below operation process.
1. Rename the user-defined EDID according the following format.
EC_xx_xxxxx_xxxx_xxx.bin
⚫ EC: Fixed value
⚫ xx: EDID ID. It is “15”.
⚫ xxxxx: Video resolution.
⚫ xxxx: Refresh rate.
⚫ xxx: Audio format.
Example: EC_15_3840x2160_60Hz_ Dolby.bin
2. Connect the FW port of transmitter to the PC with USB cable, and then power on
the transmitter, the PC will automatically detect a virtual disk named of
“BOOTDISK”.
3. Double-click to open the disk, a file named of “READY.TXT” will be showed.
4. Copy the user-defined EDID (such as EC_15_3840x2160_60Hz_Dolby.bin) to the
“BOOTDISK” disk.
5. Reopen the disk to check the filename “READY.TXT” whether automatically
becomes “SUCCESS.TXT”, if yes, the user-defined EDID was imported into the
transmitter and saved as its corresponding EDID ID successfully.
6. Remove the USB cable, and then reboot the transmitter.
7. Now the new EDID can be invoked by setting the DIP switch status to “111”.
HDCP MODE
Set the switch 4 on the “ON” position to select HDCP Active mode, or on the “OFF”
position for HDCP Passive mode.
Switch Status
Mode
HDCP
OFF (0)
Passive
(Default)
Automatically follows the HDCP version of source device.
ON (1)
Active
⚫ If the input video has HDCP content, the HDCP version
of HDMI output is HDCP 1.4 for broader video solution.
⚫ If the input video has no HDCP content, the HDMI
output has no HDCP too.
Bekijk gratis de handleiding van Ecler VEO-XTT44, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTT44 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2400 MB |
