Ecler VEO-XTI2L handleiding
Handleiding
Je bekijkt pagina 20 van 85
20
8 SYSTEM TOPOLOGY AND CONFIGURATIONS
Note: Connecting or disconnecting HDMI cables while VEO devices are switched on may
result in video signal dropouts while a stable connection is re-established.
8.1 Point-to-point connection
When the VEO-XTI2L and VEO-XRI2L are connected as a simple extension within a
point-to-point topology, no configuration is required. The devices have a default setting
of "Auto IP" (169.254.x.x), and each transmitter will send a unicast video stream to the
corresponding receiver when the same Group ID is selected. Point-to-point connection is
the default.
8.2 Point-to-multipoint connections and operations
When the VEO-XTI2L and VEO-XRI2L are connected as a distribution system within a
point-to-multipoint connection, both the transmitters and the receivers must be
configured as multicast (refer to the ‘Which functions are available when operating the
devices via EclerNet Manager?’, ‘Configuring the Casting Mode using the Control Centre’
and ‘Casting Mode’ chapters in this manual). Each receiver must be set to the same group
ID as the transmitter.
Bekijk gratis de handleiding van Ecler VEO-XTI2L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTI2L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18762 MB |
