Ecler VEO-XTI2L handleiding
Handleiding
Je bekijkt pagina 19 van 85
19
Requirements and recommendations for using a VEO IP video network
It is necessary to use gigabit switches with support for Jumbo Frame (or, if this is not
available, the ability to extend the size of the IP packet) and IGMP. This will create the
most appropriate scenario both for standalone IP video networks, and for cases where IP
video systems share the network with other data streams.
The typical transmission speed generated by these devices is approximately 300Mbps,
so the use of dedicated networks or VLANs is highly recommended. You must ensure
that the processing performance of the gigabit switch is greater than the performance
required by the VEO system.
The measured bandwidth shows the video traffic in a typical installation, providing both
the average value and the minimum and maximum performance variations (Mbps) in
the table below:
Video Resolution
Quality Level
Max Frame
Rate
Average Network
Bandwidth (Mbps)
3840x2160
(2160p30)
Auto
30
218 (146~268)
1920x1080 (1080p)
Auto
60
133 (80~210)
1280x720 (720p)
Auto
60
147 (112~177)
1600x1200 (UXGA)
Auto
60
81 (57~105)
1280x1024 (SXGA)
Auto
60
113 (79~150)
1024x768 (XGA)
Auto
60
81 (72~120)
800x600 (SVGA)
Auto
60
66 (49~82)
640x480 (VGA)
Auto
60
43 (29~56)
Bekijk gratis de handleiding van Ecler VEO-XTI2L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XTI2L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 18762 MB |
