Ecler VEO-XRI1CG2 handleiding
Handleiding
Je bekijkt pagina 9 van 34
9
PRECAUTIONS
PACKAGE
CONTENTS
DESCRIPTION
&
FEATURES
INSTALL
&
CONNECT
START-UP
&
OPERATION
PANEL
FUNCTIONS
TECHNICAL
DATA
4.2.2 VIDEO DISTRIBUTION QUICK START
To begin a video transmission, a matching between a transmitter and a receiver is
required. Each VEO-XTI1CG2 transmitter can stream a video signal over the network using
an ID channel number that must be unique in the same network. Each ID channel from 0 to
762 identifies a IP address and every VEO-XRI1CG2 receiver can select one of these
channels in order to receive an AV stream.
The ID channel for transmitters is usually set once during the setting up of the system while
the receivers ID usually are the ones that are modified in order to show different content on
the displays. The destination receiver ID must be set in the same channel as the transmitter
broadcasting the desired source audio and video content.
The ID channel can be selected in four different ways:
• By front panel buttons of the devices (VEO-XTI1CG2 has the ID assignement blocked
by default and should be adjusted entering CFN mode, long pressing DOWN button.
See chapter Additional functionalities of CH select ▲/▼ buttons for both: VEO-
XTI1CG2 AND VEO-XRI1CG2). “Button Fast Setting Local ID” can be enabled to
unblock ID assignment for VEO-XTI1CG2 front buttons CH select regular operation.
See chapter VEO-XTI1CG2 Settings for further details.
• By using the Web Page configuration on the same device.
• By using the Web Page configuration on VEO-XCTRLG2.
• Via RS-232.
• Via TCP using the VEO-XCTRLG2.
4.2.3 UNICAST MODE
When VEO-XTI1CG2 and VEO-XRI1CG2 devices are connected as a simple point to point
extension, no additional configuration is needed.
1. Connect the source device to the VEO-XTI1CG2 transmitter to the HDMI port.
2. Connect Audio IN/OUT to a sound device and select the required audio mode.
3. Connect the remote endpoint to the VEO-XRI1CG2 receiver’s HDMI port output.
4. Connect the transmitter and receiver with Cat5e/6/7 cable.
5. Connect an RS-232 cable from the automation system to the transmitter port.
6. Connect RS-232 cable from the receiver to the port of the device to control.
7. Power VEO-XTI1CG2 transmitter and VEO-XRI1CG2 receiver with the included
power adapter.
Set the same ID for both devices.
Bekijk gratis de handleiding van Ecler VEO-XRI1CG2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XRI1CG2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6592 MB |
