Ecler MIMO88SG handleiding
Handleiding
Je bekijkt pagina 9 van 33
9
5.7. GPI Remote Control Ports
The rear panel of the MIMO SG offers 8 (MIMO88SG) or 12 (MIMO1212SG) GPI inputs
for 0-10 VDC continuous control voltage. Each of these inputs can be connected to an
external physical device (potentiometer, contact closure, continuously variable voltage 0-
10V DC, etc.) and assigned to a MIMO SG function, as for example:
• Input, output channel or matrix crosspoint volume remote control by means of a
WPaVOL physical knob or an Ecler WP Series’ WPVOL-IR remote control
• MUTE or SOLO activation/deactivation by means of a switch or contact closure
• Recalling a preset with a push button or contact closure
GPI connectors are screw terminal blocks with three-contacts. The wiring is as follows:
Positive, + 12 VDC > Pin +
Variable voltage, 0-12 VDC > Pin ↑
Ground > Pin ⊥
WPaVOL connection to MIMO serial GPI ports
WPaVOL-SR connection to MIMO serial GPI ports
Connecting cables can be up to 500 meters with a minimum section of 0.5 mm
2
.
Consult your ECLER dealer or www.ecler.com about the WP series remote control wall
panels and other accessories available for connection to the GPI port.
Jumpers position: ALOG / LIN
LIN position
+12 / +10 +12 position
Jumpers position: ALOG / LIN
LIN position
+12 / +10 +12 position
WPaVOL RJ45 pin 6 (+12VDC/+10VDC)
WPaVOL RJ45 pin 2 (Remote ZONE.)
WPaVOL RJ45 pin 1, 3 or 7 (GND)
WPaVOL-SR RJ45 pin 6 (+12VDC/+10VDC)
WPaVOL-SR RJ45 pin 2 (Remote VOL.)
WPaVOL-SR RJ45 pin 1, 3 or 7 (GND)
WPaVOL-SR RJ45 pin 8 (Remote VOL.)
WPaVOL-SR RJ45 pin 1, 3 or 7 (GND)
Bekijk gratis de handleiding van Ecler MIMO88SG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | MIMO88SG |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3412 MB |
