Ecler MIMO88SG handleiding

33 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 10 van 33
10
5.8. Remote control RS-232 Port
The built-in RS-232 port in the rear panel allows an external device to communicate with
a MIMO SG unit via serial connection. Said connection uses the TP-NET protocol syntax
so to enable the external device to obtain the value of any of the parameters of the MIMO
SG unit (by "GET" commands) and/or modify said values (“SET” commands). See the TP-
NET protocol manual for more information.
The serial connection should comply with the following specifications:
Baud rate: 57600 (fixed, no auto negotiation)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
5.9. Front panel controls and LED indicators
The following elements are available on the MIMO SG
series front panel:
Input LED indicators: indicate the presence of audio signal at the unit’s input, and
its intensity level (green, amber and red indicate in this order the increased intensity
level)
Output LED indicators: indicate the presence of audio signal at the unit’s output,
and its intensity level (green, amber and red indicate in this order the increased
intensity level)
Status LED indicators (STATUS):
o DATA: Off: there is no connection to EclerNet Manager even if connected
to Ethernet. On: connected to EclerNet Manager or to other third party
application via TP-NET protocol. Flashing: data traffic with EclerNet
Manager or another application.
o POWER: Illuminates when the unit is in operation. It flashes if there is an
error in the unit or if firmware is not correct. It also flashes when you update
firmware
CLEANING
The front panel should not be cleaned with dissolvent or abrasive substances because
silk-printing could be damaged. To clean it, use a soft cloth slightly wet with water and
neutral liquid soap; dry it with a clean cloth. Be careful that water never gets into the unit
through the holes of the front panel.
WIRING RS232 DB9
RS232
DB9
Tx
Pin 2 (RxD)
Rx
Pin 3 (TxD)
Gnd
Pin 5 (Signal Gnd)

Bekijk gratis de handleiding van Ecler MIMO88SG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkEcler
ModelMIMO88SG
CategorieNiet gecategoriseerd
TaalNederlands
Grootte3412 MB