Ecler MIMO88 handleiding
Handleiding
Je bekijkt pagina 8 van 30
8
5.5 ETHERNET port for programming and control
A RJ45 type connector (11) allows connecting the equipment to an Ethernet network:
• Management from EclerNet Manager application. Please refer to the EclerNet
Manager software manual at www.ecler.com for more information.
• Possibility of direct connection (point to point) between a computer and a MIMO88
unit.
• Connection to third party other devices. (Crestron, AMX, Vity, Medialon, etc.
Registered trademarks of their manufacturers). Protocol used: Ecler TP-NET. See
the TP-NET protocol manual for more information.
5.5.1 Factory Preset Network settings
The factory default network settings for EclerNet Manager compatible devices are as
follows:
• IP: 192.168.0.100
• Mask: 255.255.255.0
• Gate: 192.168.0.1
• UDP Port: 2210
5.6 LINK BUS digital audio port
A RJ45 type connector (12) allows connecting the equipment to a second MIMO88 unit
for a two-way exchange of digital audio and control data between the two units, the
whole behaving as a real matrix with 16 inputs and 16 outputs. The maximum permissible
distance between the two units using a standard CAT5 cable is 100 meters.
To work in 16x16 mode, one of the two coupled MIMO88 units (linked by BUS LINK)
assumes the role of MASTER and the other one the role of SLAVE. MASTER or SLAVE
mode is set by the selector (13) located on the rear panel of each unit. In single MIMO88
setups, selector position is irrelevant.
In 16x16 mode, the two units behave as a single device with 16 inputs and 16 outputs.
All Ethernet programming and remote control of the MASTER-SLAVE pair is done with
EclerNet Manager application and communication uses the Ethernet port of the MASTER
unit only, it’s not necessary to use the Ethernet port of the SLAVE unit. (Except for
updating the firmware).
Caution: two MIMO88 units coupled by BUS LINK should be linked with a crossover
cable, i.e. with a CAT5 cable dedicated to the BUS LINK ports of both units, up to 100
meters long, and
without intermediate Ethernet hardware or other. Please refer to
the EclerNet Manager software manual at www.ecler.com
for more information.
Bekijk gratis de handleiding van Ecler MIMO88, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | MIMO88 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3164 MB |
