Ecler MIMO88 handleiding
Handleiding
Je bekijkt pagina 6 van 30
6
o Routing matrix/mixer, from any input to any output with adjustable level for
crossover points (independent mixes of different inputs for each output).
o Mono or stereo channel processing.
o Level control, mute, vu-meters and phase adjustment for inputs and outputs.
o Internal signal generator (sine wave, pink noise, white noise, polarity test).
o Parametric EQ on inputs and outputs.
o Delay on inputs and outputs.
o Gate/compressor on input channels.
o Compressor/limiter on outputs.
o Input channel priority assignment (ducking).
o Virtual and physical messaging consoles (paging).
o Automatic mixer.
The MIMO88 programming is done with EclerNet Manager application. Please refer to the
EclerNet Manager software manual at www.ecler.com for more information.
5 INSTALLATION
5.1 Location, assembly, ventilation
The MIMO88 has been especially designed to be installed in a standard 19" rack, taking
up 1U.
It is very important not to enclose the MIMO88 or expose it to extreme temperatures as it
generates heat. It’s also necessary to promote the passage of fresh air through the
ventilation holes of the chassis, leaving at least one rack unit off between each device and
installed above and below it in the rack frame.
If the setup has several amplifiers in the same rack or in a closed cabinet with doors, it is
highly recommended to supply them forced ventilation, installing fans at the upper and
lower ends. This upward air flow will help to dissipate the heat generated inside.
5.2 Connection to an AC outlet and switching on
The MIMO88 operates under voltages between 90 and 264 V at 47 to 63 Hz. This device
features an over dimensioned power supply that adapts to the mains voltage in any
country of the world with no need to make any adjustments.
On the rear panel, there is a power switch for the unit (20) next to the IEC power
connector. On the front panel, a LED (7) lights up when the unit is switched on.
The mains cables must not be near the shielded cables carrying the audio signal, as this
could cause humming.
Bekijk gratis de handleiding van Ecler MIMO88, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | MIMO88 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3164 MB |
