Eaton Green Motion XCI000411 handleiding
Handleiding
Je bekijkt pagina 104 van 107
11. Troubleshooting
If the problem persists, contact your Eaton technical support representative using the email address
BGTechSupport@eaton.com.
This section contains information and procedures for solving possible problems that may occur with the Green
Motion Building EV charger.
Possible problems Solutions
The EV charger is unresponsive; nothing
happens when connecting it to a vehicle.
Check that the EV charger is correctly connected to a power supply. The LED indicator should be solid green.
The EV charger LED indicator is
solid red.
There is an error or fault preventing a charging session to either start or resume.
Attempt to reinitiate the charging session by unplugging the charging cable from the vehicle and reinserting it. If the
problem persists, check any control messages displayed in the vehicle.
The EV charger LED indicator is green,
but the vehicle does
not charge.
Check that the charging cable connector is adequately plugged into the vehicle. When charging with a Type 2 connector,
ensure that it is pushed in until an audible click is heard.
Some vehicles need to be locked before a charging session is allowed to start. Try locking the vehicle.
Visually inspect the condition of the cable used for charging, its connector and sockets, the vehicle socket as well as the EV
charger socket if using a Green Motion Building EV charger with a Type 2 socket. Stop usage immediately if you see physical
damage to any of these parts.
Check that the vehicle does not have scheduled/delayed charging set up. In such cases it will only charge at certain hours of
the day.
The charging cable connector will not
release from the vehicle or the
EV charger.
In most cases the charging cable must first be released/unlocked by the vehicle to prevent injuries, accidental
disconnection and misuse. Try unlocking the vehicle first. Alternatively, refer to the vehicle instruction manual.
The plug does not release. Due to the weight of the 22 kW connector cable, it is possible that the latch on your vehicle will not release.
In this case, firmly hold the plug slightly upwards as you disconnect the plug from the vehicle.
Table 34. Troubleshooting
104
GREEN MOTION BUILDING INSTALLATION MANUAL MN191028EN April 2024 www.eaton.com
Bekijk gratis de handleiding van Eaton Green Motion XCI000411, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eaton |
| Model | Green Motion XCI000411 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16416 MB |
