Easymaxx 07839 handleiding
Handleiding
Je bekijkt pagina 2 van 2
Kundenservice / Importeur | Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin
Deutschland | Germany
Tel.: +49 38851 314650 *
* Anruf in das deutsche Festnetz zum Tarif Ihres Anbieters.
Calls to German landlines are subject to your provider’s charges.
Operating Instructions
EN
Dear Customer,
We are delighted that you have chosen our LED solar spot-
light.
If you have any questions about the product and about spare
parts/accessories, contact the customer service department
via our website: www.ds-group.de/kundenservice
Information About the Operating Instructions
Before using the product for the first time, please read through
these operating instructions carefully and keep them for future
reference and other users. They form an integral part of the
product. The manufacturer and importer do not accept any
liability if the information in these operating instructions is not
complied with.
SYMBOLS
Danger symbol: This symbol indicates possible haz-
ards. Read the associated safety notices carefully and
follow them.
Supplementary information
Direct current
Read the operating instructions before use!
SIGNAL WORDS
Signal words indicate hazards if the associated notices are not
followed.
WARNING – medium risk, may result in serious injury or death
NOTICE – may result in risk of damage to material
INTENDED USE
■ The product is used for illuminating outdoor areas. The
battery charges up in daylight via the solar panel. This
stored energy allows the LEDs to glow in the dark as well.
■ The motion sensor records
movements in dark environ-
ments with coverage of around 120 degrees within a radius
of approx. 5 – 8 metres.
Note that the motion sensor can also be triggered by pets
or wild animals!
■ The product is designed for personal use only and is not
intended for commercial applications.
■ The product should only be used as described in the
operating instructions. Any other use is deemed to be
improper.
SAFETY NOTICES
WARNING – Danger of Injury!
■ Keep the packaging material away from children and animals.
There is a danger of suffocation!
■ The product is not a toy. Do not leave children and animals
unsupervised in order to avoid injuries!
■ Never look directly into the LEDs! This could damage your
eyes.
■ Batteries can be deadly if swallowed. The battery and the
remote control should be kept out of the reach of children
and animals. There is a danger of burns from battery acid!
If a battery is swallowed, medical attention must be sought
immediately.
■ If the battery leaks, do not allow your skin, eyes and
mucous membranes to come into contact with the battery
acid. There is a danger of burns.
If you touch battery acid
,
rinse the affected areas with abundant clear water straight
away and seek medical assistance immediately.
■ Do not use the product if the battery is leaking.
NOTICE – Risk of Damage to Material and Property
■ Use only the battery type specified in the technical data.
■ Take the battery out of the remote control when it is dead
or if you will not be using the product for a prolonged peri-
od. This will prevent any damage caused by leaks.
■ Remove a leaking battery immediately.
■ Do not take apart the motor unit with built-in battery.
Protect it from: fire, high temperatures of over 50°C, direct
sunlight and sub-zero temperatures. The battery could
ignite or explode. Do not store the product in a vehicle
where it might be exposed to extreme temperatures.
■ Use suitable fixings to mount the product on a wall. If you
are unsure whether the fixings supplied with the product
are suitable, seek advice from a specialist stockist.
■ Fix the product on a stable surface.
■ Before drilling, ensure that there are no pipes or cables be-
hind the intended drilling point.
■ Protect the product from flames, heat sources and impacts.
■ Never immerse the product in water or other liquids! It is
only resistant to splashing.
■ During extreme weather conditions (e.g. storm, hail) or if
it is not going to be used for a long time, switch off the
product and store it in a dry place.
■ Do not make any modifications to the product. Do not take
the product apart and do not attempt to repair it. Contact
the customer service department if there is any damage.
■ The individual LEDs cannot be replaced.
ITEMS SUPPLIED
1 x
solar spotlight (lamp head incl. 3.7 V battery, wall mounting
bracket and integrated motion sensor) with solar unit
1 x base for solar unit
1 x ground spike
1 x fixings (2 x anchors; 2 x screws)
1 x remote control incl. 3 V button cell battery (CR2025)
1 x operating instructions
Check the items supplied for completeness and the product
for transport damage. If you find any damage, do not use the
product but contact our customer service department.
Remove any possible films, stickers or transport protection
from the product. Never remove the rating plate and any
possible warnings!
POSITIONING
L
The solar spotlight should not be placed near to other
light sources such as street lamps or other lamps, so
that the motion sensor can respond and the LEDs can
be switched on automatically.
Place the solar spotlight in a location where the solar
unit can absorb direct sunlight all day long if possible.
Thanks to the connecting cable, the solar unit can be
positioned flexibly within a radius of up to 3 m.
Wall Mounting
1. Place the wall mounting bracket on the shaft of the lamp
head on the wall and mark out two drill holes.
2. Drill holes into the wall and place anchors in them.
3. Then fix the wall mounting bracket in place with screws
and tighten.
Ground Spike
1. Push the ground spike into the shaft of the lamp head.
2. Anchor the ground spike in the ground.
Solar Unit
1. Slide the solar unit onto the lamp head from behind until it
engages.
2. To detach the solar unit from the lamp head, pull on the
locking lug and pull the solar unit off the lamp head.
Alternatively, the solar unit can also be attached to the base.
CHANGING THE BATTERY IN THE
REMOTE CONTROL
L
The battery is already inserted. All you need to do is
pull out the transport safeguard.
Before inserting the battery, check whether it is clean and
clean it if necessary.
1. The battery compartment is
located on the narrow side of
the remote control. Pull it out as
shown.
2. Take out the used battery and in-
sert a new battery (3 V, CR2025).
The positive pole must be facing
upwards.
3. Slide the battery compartment into the remote control. You
should feel and hear it click into place.
SWITCHING ON AND OFF
• Slide the On / Off switch on the bottom of the lamp head
to the right to switch on the product.
L
If the product has been switched on using the On / Off
switch on the lamp head, the product can also be con-
trolled using the remote control.
In order to check if the product is switched on during day-
light, cover the solar unit with your hand. If the LEDs light
up, the product is switched on.
When the product is switched on, the battery can charge up
in daylight.
• When darkness sets in, the motion sensor and the LEDs
become active. Three different modes can be set:
Mode 1
• The LEDs are switched off.
• When any movement is registered, the LEDs
switch on at 100% brightness.
• The LEDs switch off after around 20 seconds
without registering a movement.
Mode 2
• The LEDs are switched off.
• When any movement is registered, the LEDs
switch on at 100% brightness.
• The LEDs switch to 20% brightness after
around 20 seconds without registering a
movement.
Mode 3
• During darkness, the LEDs light up con-
stantly at 30% brightness.
• The motion detector is deactivated.
The modes can be set by pressing the corresponding but-
tons 1, 2, 3 on the remote control.
• When the product is not in use, switch it off by sliding the
On / Off switch to the left.
Please Note: The battery performance may be severely re-
stricted in temperatures well below freezing.
CLEANING
• Keep the solar unit clean so that the greatest possible
absorption of light is ensured. Wipe down the solar panel
(and if necessary also the remaining components of the
product) with a damp cloth.
• Do not use any caustic or abrasive cleaning agents to clean
the product! These might damage the surfaces.
• When it is not in use, you should store the product in a
dry, clean location which is out of the reach of children and
animals.
TECHNICAL DATA
Article number: 07839
Model number:
KXK-600C
Power supply:
○ Spotlight: 3.7 V DC (2 x Li-ion battery,
2400 mAh)
○ Remote control: 3 V DC (1 x button cell, CR2025)
Battery charge time: approx. 8 – 10 hours (in sunshine)
Nominal luminous flux: approx. 400 lm
Motion sensor:
○ Coverage angle: approx. 120°
○ Range: approx. 5 – 8 m
Protection class: III
Type of protection: IP64
ID
of operating instructions
:
Z 07839 M DS V1 1022 mh
DISPOSAL
Dispose of the packaging material in an environmental-
ly friendly manner so that it can be recycled.
The adjacent symbol (crossed-out bin underlined)
means that used devices should not be disposed of
in the domestic waste, but should instead be taken to
special collection and return systems.
Owners of used devices must remove from the used
device any used batteries or rechargeable batteries which
are not encapsulated by the used device and can be
removed in a non-destructive way and dispose of them
separately (see also the section on battery disposal).
Owners of used devices from private households can
take them free of charge to the collection points of
the public waste disposal authorities or the disposal
points which are set up by manufacturers and distrib-
utors under the Electrical Equipment Act. Businesses
which market electrical and electronic devices are also
obliged to take back used devices.
Non-rechargeable and rechargeable batteries must
not be disposed of along with the household waste.
Consumers are legally obliged to separate and recycle
non-rechargeable and rechargeable batteries.
Non-rechargeable and rechargeable batteries can
be taken free of charge to a collection point of your
local authority/district or in shops so that they can be
disposed of in an environmentally friendly way and
valuable raw materials can be recovered. If they are
not disposed of properly, toxic ingredients may enter
the environment and have harmful effects on people,
animals and plants.
Only dispose of non-rechargeable and rechargeable
batteries when they are discharged.
With non-rechargeable and rechargeable batteries
that contain lithium, cover the poles before disposing
of them to prevent a short circuit. A short circuit may
cause a fire or explosion.
All rights reserved.
Bekijk gratis de handleiding van Easymaxx 07839, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Easymaxx |
| Model | 07839 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 779 MB |
