Durkopp Adler D888 handleiding
Handleiding
Je bekijkt pagina 231 van 264
Troubleshooting
Operating Instructions D888 e-con - 00.0 - 12/2023 229
9362 Error Edge guide y-axis pcb is not
connected
• Check connection cables
• Perform software update
• Replace PCB
9370 Warning Scanner module not
connected
• Check connection cables
• Perform software update
• Replace scanner module
9371 Warning Scanner module 24 V Error • Check connection cables
• Check connected scanners
• Replace scanner module
9372 Warning Scanner module 5 V Error • Stored analogue value for stroke
9910 Warning Sewing stop • Check tilt sensor on machine
• Check 24V
• Replace the control
9911 Warning Power down • The control is switched off
9912 Warning Restart necessary • Switch off the control
9913 Warning Empty bobbin • Please insert a full bobbin
9914 Warning Reset • Remove USB key!
9915 Warning Please Wait! • Please wait and do not remove USB key
9916 Warning Erase internal Memory • Delete the SD card. Continue with OK;
cancel with ESC
9917 Warning Erase USB key • Delete the USB key. Continue with OK;
cancel with ESC
9918 Warning No USB key present • Please insert USB key
9919 Warning Sewing stop • Machine in stop mode for threading
the thread
9920 Warning Referencing • Please wait for motor referencing
9921 Warning Show Message from
QONDAC
• Show Message
9922 Warning Service Stop • Check the Service Stop button
• Check 24V
• Replace the control
9923 Warning Update required • Press OK for Restart or ESC for cancel
Code Type Possible cause Corrective
Bekijk gratis de handleiding van Durkopp Adler D888, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D888 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 27738 MB |
