Durkopp Adler D888 handleiding
Handleiding
Je bekijkt pagina 222 van 264
Troubleshooting
220 Operating Instructions D888 e-con - 00.0 - 12/2023
3223 Information No loop (right) Skip stitch monitor
• The sensor of the skip stitch monitor
detected during the sewing process that
the loop of the needle thread was not
taken up, resulting in a “skip stitch”.
3224 Information Bobbin Rotation Monitor • The bobbin is not rotating
• Check the bobbin, advance the initial
thread
3225 Information SSD sensor is soiled • Use compressed air or a soft cotton cloth
to clean the sensor
3226 Information No loop (left) Skip stitch monitor
• The sensor of the skip stitch monitor
detected during the sewing process that
the loop of the needle thread was not
taken up, resulting in a “skip stitch”.
3227 Information Bobbin Rotation (left) Bobbin Rotation Monitor
• The sensor of the bobbin rotation monitor
detected during the sewing process that
no hook thread was consumed and that
the seam was apparently not created
properly.
3228 Information Clean Loop Control sensor
(left)
Sensors soiled
• The optical sensors for the skip stitch
monitor, the bobbin rotation monitor and
the remaining thread monitor are soiled
and deliver no reliable signal.
Please clean dirt off the sensors using
compressed air or a soft brush.
3354 Information Failure in thread trimmer
process
• Perform software update
3383 Information Failure in the motor
referencing process
• Check motor
• Perform software update
Code Type Possible cause Corrective
Bekijk gratis de handleiding van Durkopp Adler D888, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D888 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 27738 MB |
