Durkopp Adler D888 handleiding
Handleiding
Je bekijkt pagina 149 van 264
Programming Commander DELTA
Operating Instructions D888 e-con - 00.0 - 12/2023 147
5.9.6.1 Scan Mode
Before a chip can be read and stored for the first time, you must
select Read & Store.
To check if the chip is the chip that has been stored, you must
select Read & Compare.
Different messages may be displayed during the scan process/
sewing:
• Scan required: Please scan the RFID tag.
• Scan required: Please scan the same RFID tag again.
• Scan again as RFID tags did not match: The Read & Compare
found that the chips did not match. Please scan the same
RFID tag as before.
Another scan required: Please scan the same RFID tag again.
First bartack section
The 1
st
section of the bartack can be
programmed with a different number of
stitches. All subsequent sections have
the preset number of stitches from
the settings for the start bartack.
On/Off
Number of stitches
Value range
01 – 50 [stitches]
Last bartack section
The last section of the bartack can be
programmed with a different number of
stitches. All previous sections have
the preset number of stitches from
the settings for the start bartack.
On/Off
Number of stitches
Value range
01 – 50 [stitches]
Invert bartack direction
Normally, a bartack starts either with the
sewing direction (forwards – even number
of sections) or against the sewing direction
(backwards – odd number of sections),
depending on the number of sections.
Setting this parameter inverts the sewing
direction of the bartack.
Value range
On/Off
Icon Parameter Settings
Bekijk gratis de handleiding van Durkopp Adler D888, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D888 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 27738 MB |
