Durkopp Adler D888 handleiding
Handleiding
Je bekijkt pagina 133 van 264
Programming Commander DELTA
Operating Instructions D888 e-con - 00.0 - 12/2023 131
Bobbin monitor mode (see p. 134)
Counter Mode
Daily piece counter, can be set to count
either up or down.
Off/Up/Down
Reset
When the daily piece counter is
activated, it must be reset once after
entering a value to ensure it counts
correctly.
Point position
The distance of the needle from
the material can be adjusted to allow
precise positioning of the sewing
material when starting sewing.
The value entered corresponds to
the degree number on the handwheel.
Value range
000 – 359 [°]
Flat Sew
Transport correction at zero difference
for Flat Sew.
Value range
-20–20
Material thickness detection
Material thickness detection Value range
On/Off
( p. 141)
Sewing foot stroke The sewing foot stroke can be adjusted
to different material thicknesses by the
software.
Stitch length The stitch length changes slightly
depending on the material thickness.
For this reason, the stitch length can
be adjusted to different material
thicknesses by the software.
Needle thread tension Depending on the material thickness,
the needle thread tension can be
adjusted to different material
thicknesses by the software.
Icon Parameter Settings
Bekijk gratis de handleiding van Durkopp Adler D888, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D888 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 27738 MB |
