Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 239 van 286
Troubleshooting
Operating Instructions D867 e-con - 00.0 - 06/2023 237
8174 Error Stepper Puller Bottom init
position not found
• Check for stiff movement
• Replace encoder
• Replace motor
8175 Error Stepper Puller Bottom not
enabled
• Replace the control
8176 Error Stepper Puller Bottom
overload
• Check for stiff movement
• Replace encoder
• Replace motor
8177 Error Stepper Puller Bottom
encoder failure
• Connect encoder cable to the control:
Use correct connection
8178 Error Stepper Puller Bottom
Current sensor failure
• Replace the control
8179 Error Stepper Puller Bottom
Incorrect stepping motor
direction of rotation
• Replace encoder
• Check if plugs have been mixed up
• Check the wiring in the machine distribu-
tor and change it if necessary
8180 Error Stepper Puller Bottom refer-
ence drive failure
• Check for stiff movement
• Replace encoder
• Replace motor
8181 Error Stepper Puller Bottom
overcurrent
• Replace the control
8182 Error Stepper Puller Bottom
parameter initialization
• Perform software update
• Check selection of class
8183 Error Stepper Puller Bottom
insulation error
• Check motor phase and PE for low-
impedance connection
• Replace encoder
• Replace motor
8185 Error Stepper Puller Bottom trans-
port interval failure
• Perform software update
• Check selection of class
8186 Error Stepper Puller Bottom refer-
ence drive failure
• Check for stiff movement
• Replace encoder
• Replace motor
8201 Error Stepper card reference drive
timeout (Edge guide)
External Edge guide X Axis
• Check reference sensor
Code Type Possible cause Corrective
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
