Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 163 van 286
Programming Commander DELTA
Operating Instructions D867 e-con - 00.0 - 06/2023 161
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Value range
01 - 99
Stop-Time for direction change
The waiting time at the turning points
(e.g. for a change of sewing direction) is set
at this point. A short waiting time in millisec-
onds should ensure consistent seam qual-
ity (ornamental-stitch bartack).
Value range
0000 – 1000 [ms]
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as the
one set in Manual mode. If this function is
deactivated, a custom input can be
entered.
On/Off
Stitch length of
backwards stitches
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Stitch length of stitches
forward
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Sewing speed Value range
50 - 2000
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set
very low for the bartack.
Value range
On/Off
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as
the one set in Manual mode. If this function
is deactivated, a custom input can be
entered.
On/Off
Needle thread tension
Value range
01 - 99
Icon Parameter Setting
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
