Durkopp Adler D867 e-con handleiding
Handleiding
Je bekijkt pagina 155 van 286
Programming Commander DELTA
Operating Instructions D867 e-con - 00.0 - 06/2023 153
5.10.6.1 Scan Mode
Before a chip can be read and stored for the first time, you must
select Read & Store.
To check if the chip is the chip that has been stored, you must
select Read & Compare.
Different messages may be displayed during the scan process/
sewing:
• Scan required: Please scan the RFID tag.
• Scan required: Please scan the same RFID tag again.
• Scan again as RFID tags did not match: The Read & Compare
found that the chips did not match. Please scan the same
RFID tag as before.
• Another scan required: Please scan the same RFID tag again.
First bartack section
The 1
st
section of the bartack can be
programmed with a different number of
stitches. All subsequent sections have
the preset number of stitches from the
settings for the start bartack.
On/Off
Number of stitches
Value range
01 - 50
Last bartack section
The last section of the bartack can be
programmed with a different number of
stitches. All previous sections have the
preset number of stitches from the settings
for the end bartack.
On/Off
Number of stitches
Value range
01 - 50
Invert bartack direction
Normally, a bartack starts either with the
sewing direction (forwards – even number
of sections) or against the sewing direction
(backwards – odd number of sections),
depending on the number of sections.
Setting this parameter inverts the sewing
direction of the bartack.
Value range
On/Off
Icon Parameter Setting
Bekijk gratis de handleiding van Durkopp Adler D867 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | D867 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 32197 MB |
