Durkopp Adler 550-D869-100 e-con handleiding
Handleiding
Je bekijkt pagina 105 van 198
Programming Commander DELTA
Instructions for use 550-D869-100 e-con - 00.0 - 01/2025 103
Adjustments for seam end bartack parameters
Bartack at seam end Value range
On/Off
Number of stitches backwards Value range
01 - 50
Number of stitches forward Value range
01 - 50
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Value range
01 - 99
Stop-Time for direction change
The waiting time at the turning points
(e.g. for a change of sewing direction) is
set at this point. A short waiting time in
milliseconds should ensure consistent
seam quality (ornamental-stitch bartack).
Value range
0000–1000 [ms]
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as the
one set in Manual mode. If this function is
deactivated, a custom input can be
entered.
On/Off
Stitch length of stitches forward
Value range
0.1–9.0 [mm]
(depending on subclass)
Stitch length of backwards stitches
Value range
0.1–9.0 [mm]
(depending on subclass)
Speed in bartack Value range
0000 - 2000
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set
very low for the bartack.
Value range
On/Off
Button Parameter Settings
Bekijk gratis de handleiding van Durkopp Adler 550-D869-100 e-con, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Durkopp Adler |
| Model | 550-D869-100 e-con |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 18809 MB |
