Dremel Multi-Max MM35 handleiding
Handleiding
Je bekijkt pagina 10 van 56
Note: Some accessories, such as scrapers or blades,
may be mounted either straight on the tool, or at an
angle to enhance usability (Fig. 6).
In order to do this with the Easy-Lock interface, place
the accessory onto the accessory holder making
sure the accessory engages all pins in the holder and
the accessory is flush against the accessory holder.
Securely lock the accessory in place as described
previously (Fig. 2).
REMOVING ACCESSORIES WITH
EASY-LOCK ACCESSORY CHANGE
1. To remove an accessory, first loosen the clamping
knob by twisting it in a counter-clockwise direction
(Fig. 2).
2. Press the clamping knob and lift the accessory
bracket to take it off the pins. You may need to
loosen the clamping knob more to allow adequate
room to remove the accessory. (Fig. 3)
Note: Blade may be hot after use, wait for blade to
cool down before touch.
-10-
LEARNING TO USE THE TOOL
Getting the most out of your oscillating tool is a matter
of learning how to let the speed and the feel of the tool
in your hands work for you.
The first step in learning to use the tool is to get the
“feel” of it. Hold it in your hand and feel its weight and
balance (Fig. 7). Depending on the application, you will
need to adjust your hand position to achieve optimum
comfort and control. The unique comfort grip on the
body of the tool allows for added comfort and control
during use.
Operating Instructions
FIG. 7
FIG. 6
INSTALLING AND REMOVING
SANDING SHEETS
Your backing pad uses hook-and-loop backed
sandpaper, which firmly grips the backing pad when
applied with moderate pressure.
1. Align the sanding sheet and press it onto the
sanding plate by hand.
2. Firmly press the power tool with the sanding sheet
against a flat surface and briefly switch the power
tool on. This will promote good adhesion and helps
to prevent premature wear.
3. To change, merely peel off the old sanding sheet,
remove dust from the backing pad if necessary,
and press the new sanding sheet in place.
After considerable service the backing pad surface
will become worn, and the backing pad must be
replaced when it no longer offers a firm grip. If you
are experiencing premature wear out of the backing
pad facing, decrease the amount of pressure you are
applying during operation of the tool.
For maximum use of abrasive, rotate pad 120 degrees
when tip of abrasive becomes worn.
editing_1600A014GW MM35 201808.indd 10editing_1600A014GW MM35 201808.indd 10 7/28/2023 9:58:51 AM7/28/2023 9:58:51 AM
Bekijk gratis de handleiding van Dremel Multi-Max MM35, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dremel |
| Model | Multi-Max MM35 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6867 MB |
