Draytek VigorSwitch P2542x handleiding
Handleiding
Je bekijkt pagina 20 van 359
12
I-2-4 Configuring the Management Agent of Switch
Users can monitor and configure the switch through the following procedures.
There are several ways to configure and monitor the switch through Ethernet port, includes Web-UI
and SNMP.
I-2-5 Managing VigorSwitch through Ethernet Port
Before start using the switch, the IP address setting of the switch should be done, then perform the
following steps:
1. Set up a physical path between the configured the switch and a PC by a qualified UTP Cat. 5e
cable with RJ-45 connector.
Note:
If PC directly connects to the switch, you have to setup the same subnet mask between them. But,
subnet mask may be different for the PC in the remote site. Please refer to the above figure
about the Web Smart Switch default IP address information.
2. After configuring correct IP address on your PC, open your web browser and access switch's IP
address.
Default system account is "admin", with password "admin" in default. Switch IP address is
"192.168.1.224" by default with DHCP client enabled.
Bekijk gratis de handleiding van Draytek VigorSwitch P2542x, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draytek |
| Model | VigorSwitch P2542x |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 65198 MB |
