Draper Expert 13590 handleiding
Handleiding
Je bekijkt pagina 10 van 16
6. Operating Instructions
– 10 –
6.4 To operate the pump - Fig. 3 & 4
1. Always check the hydraulic uid level before
using, following the instructions in the
Maintenance section.
2. Determine which direction the frame needs to
be bent.
3. Remove any obstructions that could be damaged
or are in the way.
4. Position the pump unit on a stable, at and level
surface.
5. Close the release valve (5) by turning it clockwise until
it is rmly closed. Pump the handle to apply pressure.
3 Fig.
6. Turn the release valve (5) counter-clockwise to
release the pressure.
4 Fig.
Note: The pump unit may be positioned horizontally
or vertically. When using the hydraulic pump (3) in a
vertical position, always keep the hose (6) end of the
hydraulic unit downwards.
6.5 To operate the ram
1. Connect the appropriate base (C), (D) or (G) to the
stationary side of the ram (9) and connect the
appropriate head to the pushing end of the ram.
Note: When repairing larger body panel dents such as a
dented door, fender or quarter-panel use the rubber head
(J) on the pushing end.
2. If using the at base (C) or ram toe (D): Remove the
protection cap (11). Then thread the at base onto
the ram completely and align the ram toe to it. The
at base and ram toe must be used together to
prevent an o-centre load.
3. Position the ram (9) so that the base is resting against
a frame member opposite the damaged area. It must
also be in line with the direction in which the
damaged area needs to be pushed. The vehicle body
part must be stronger than the area to be bent or it
may be damaged. A block of wood or a towel may be
used to protect the body part.
4. Aim the pushing end towards the area that needs
to be repaired and slowly apply pressure with the
pump (3).
Note: To prevent damage, do not overextend the ram.
6.6 To operate the spreader
1. Place the spreader (A) so that the hinged (pushing)
arm is resting against the part to be moved and the
stationary arm is resting against a non-movable base.
2. Carefully hold the spreader in position and apply
pressure with the pump (3).
• Warning!
• Once both ends have made contact, move as far
away as possible and continue to slowly apply
pressure to the damaged area until the desired
bend has been made.
CAUTION! Keep hands away from contact
areas and tight spaces. The tool may slip and
cause injury.
• When the damaged area has been bent to the desired
position, slowly turn the release valve (5) counter-
clockwise to release the hydraulic pressure and
remove the ram (9) or spreader (A).
• Clean all hydraulic ports and cover them with clean
dust covers to prevent contamination and damage.
(2)
(5)
(5)
Bekijk gratis de handleiding van Draper Expert 13590, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | Expert 13590 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1688 MB |
