Draper D20 98501 handleiding
Handleiding
Je bekijkt pagina 8 van 20
– 8 –
– Set up the charger and cable in a safe place where it won’t be knocked, tripped over,
stepped on, etc. and where it is well ventilated. Make sure the ventilation slots in the
charger case are not obstructed, plug the charger into the socket outlet.
– Inspect the battery pack for damage, if it is undamaged, plug it into the charger, ensuring
the correct orientation. (Most chargers and batteries have ‘keys’ etc, to make sure the
battery pack is not inserted incorrectly, if you are having to ‘force’ the battery pack into
the charger, the chances are you have it the wrong way round, check and try again.)
– Switch the charger on and check that the correct indicators illuminate, allow the battery
pack to charge (see the specic instructions for your charger). Once charging is complete,
switch the charger o, remove the battery pack and store, repeat the procedure if you
have more than one battery pack to charge.
Caution: When the battery charger has been continuously used, the battery charger will be
hot. Once the charging has been completed, give 15 minutes rest until the next charge.
– After charging is complete, unplug the charger from the socket outlet by pulling on the
plug. Do not pull on the cable. Store the charger in a dry secure place.
– If, when the charger was switched on, the correct indications did not occur, leave for
two or three minutes to allow the charger to stabilise, if the correct indications occur,
allow the charging cycle to proceed as normal. If no indication appears at all, switch o,
remove the battery pack, unplug the charger, check that the charger contacts and the
battery contacts are clean and repeat the process. If there is still no indication, switch
o, remove the battery pack, unplug the charger and check the fuse. If the fuse is blown,
replace and repeat the process. If the fuse blows again, or if the fuse was intact, attempt
no further action. Refer the charger to a suitably qualied person for repair.
Battery packs
– Before charging, read the instructions.
– For indoor use. Do not expose to rain.
– Only use Draper D20 battery packs with this product. Consult your Draper stockist for
details.
– Do not charge any other manufacturer’s battery packs using Draper chargers. Any other
application is considered misuse.
– The battery must be removed from the appliance before it is recycled.
– The charger must be disconnected from the supply mains when removing the battery.
– The battery is to be disposed of in-line with local authority procedures.
– Do not use any other than the designated Draper batteries/chargers with this product.
– Do not crush, open or burn the battery. Exposure to potentially harmful materials may
occur.
– In case of re use CO2 or dry chemical extinguisher.
– Do not expose to high temperatures >50°C. The battery may degrade at high temperatures.
– Charge battery in conditions between 5°C to 30°C with the specied charger designed for
this battery.
– Do not use battery if it has been stored at 5°C or less. Allow it to “normalise” at room
temperature before usage/charging.
Warning!
• Leaking battery packs
– The electrolyte in battery packs is corrosive. Avoid contact with the skin.
– If contact is made, ush the area with running water, pat dry and seek medical
attention and advice at the earliest opportunity.
– Inform medical personnel that the contaminant is a “high alkaline, corrosive liquid”.
– If electrolyte comes into contact with the eyes, ush with copious amounts of
water only. Seek medical attention immediately, relaying the information above.
5. HEALTH AND SAFETY INFORMATION
Bekijk gratis de handleiding van Draper D20 98501, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 98501 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 3117 MB |
