Draper D20 98501 handleiding
Handleiding
Je bekijkt pagina 14 van 20
– 14 –
8. PREPARING THE VACUUM CLEANER
If the battery is charged when it is warm due to battery
use or exposure to sunlight, the battery will not be
recharged. In such a case, let the battery cool before
charging.
If the red indicator ickers rapidly at 0.2 second intervals,
check or and remove any foreign objects in the charger’s
battery slot. If there are no foreign objects, it is probable
that the battery or charger is malfunctioning. Allow
battery/charger to normalise and try again. If a fault
remains after trying this then contact Draper Tools.
8.5 BATTERY PACK PROTECTION
FEATURES
Overcharging protection: This feature that ensures that
the battery pack can never be overcharged. When the
battery pack reaches full charge capacity, the
transformer/charger will automatically shut o,
protecting the internal components from being damaged.
Over-discharging protection: This feature will stop the
battery pack from discharging beyond the recommended
lowest safety voltage.
Overheating protection: The battery pack contains an
internal thermistor cut-o sensor which shuts o the
battery pack should it become too hot during operation.
This can happen if the tool is overloaded or being used
for extended periods. Up to 30 minutes cooling time may
be required, depending on ambient temperature.
Current protection: Should the battery be overloaded
and the maximum current draw be exceeded, the battery
will shut o to protect the internal components. The
battery pack will resume working once excessive current
draw has returned to normal, safe level.
Short circuit protection: If, for any reason, the battery
pack was to short circuit, the short circuit protection
would immediately stop the battery pack from operating.
8.6 BATTERY PACK CHARGE STATUS
– FIG. 7
To display the amount of charge left in the battery pack, press the charge level indicator
button .
8.7 BATTERY LIFE EFFICIENCY AND CHARGING ADVICE
– Avoid recharging at high temperatures. A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after use, its internal chemical substance will
deteriorate, and the battery life will be shortened. Leave the battery and recharge it after it
has cooled for a while.
– The battery should only be used and/or charged when battery temperature is between 5°C
and 30°C.
– The battery needs to be warmed-up or cooled down in order to prevent damage to the
batteries internal components,
Note: If battery is too hot or too cold, allow it to ‘normalise’ before use or charging.
Note: Failure to warm up or cool down a battery could result in serious damage to the battery,
charger and user.
FIG.7
Amount of charge
remaining
0 – 10%
10 – 25%
25 – 50%
50 – 75%
75 – 100%
Charge level
indicator
.
Bekijk gratis de handleiding van Draper D20 98501, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 98501 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 3117 MB |
