Handleiding
Je bekijkt pagina 8 van 11
–
8
–
mode.
− Adjust the Volume control on your iPod, MP3 or CD
player to ensure an adequate signal and then adjust
the volume on the speaker for comfortable listening.
− To have the better sound quality, we recommend
setting the volume to more than two-thirds level on
your audio device and then adjust the volume on the
speaker as required.
Note: When Aux in socket is connected to an audio
device, wireless connection will be disabled to minimize
power consumption.
4
FIG.
(9)
6.5 BATTERY PACK CHARGING – FIGS.
5 – 6
This power product is supplied “bare”, without battery
pack or charger. Compatible batteries, chargers and
accessories are available through Draper Tools stockists.
Important: Only Draper D20 designated battery packs
and chargers can be used in conjunction with this
product. Use of any other third party battery packs/
chargers with this product is considered misuse and will
invalidate the product’s warranty.
Once connected to the mains supply, recharging of the
battery can be left generally unsupervised, requiring
minimal attention. Complex circuit construction monitors
the battery condition, adjusting the recharge current to
suit. When the recharge cycle is complete, to maintain
the full capacity, a low output current will continue as
required.
Warning! Check the condition of the charger and
battery prior to each charge. If there is any sign of
damage then do not commence charging, seek advice
from Draper Tools.
The battery pack is supplied un-charged and must be
charged before initial use.
To charge the battery pack (12), it must first be removed
from the tool.
5
FIG.
(8)
(11.2)
To release the battery pack:
− Press the battery release button (11.1) and gently
slide the battery pack off.
− Plug the battery charger (12) unit into a power
socket.
− The red LED (12.1) will illuminate to show the
charger has power.
− Slide the battery into the charger (the battery is
shaped to fit into the charger one way only.
− After a few seconds delay, the red LED (12.1) will
flash to show that charging has begun, then
illuminate solid red.
− Whilst the battery is charging, the green LED (12.2)
will flash, (the red LED will go from flashing to
constant red.
− When the battery is fully charged the green LED
stops flashing and remains a constant green. The red
LED will extinguish.
Caution: Do not pull the plug out of the power supply by
pulling on the cord. Make sure to grasp the plug when
removing from power supply to avoid damaging the cord.
To remove the battery from the battery charger:
− Supporting the battery charger with hand, pull out
the battery from the battery charger.
Caution: If the battery charger has been in continuous
use it will be hot. Once the charging has been
completed, leave the charger 15 minutes to cool until
next use.
Bekijk gratis de handleiding van Draper D20 98436, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | D20 98436 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 2060 MB |