Draper 80947 handleiding

20 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 13 van 20
– 13 –
EN
13Fig.
8. Operating Instructions
Important: Before use, read and understand all the
safety instructions listed in this manual.
WARNING! ALWAYS ensure that the product is

supply until it is ready to be used.
8.1 Preparing the Dust Extractor
Before switching on the product, complete the following
steps and checks:
1. Position the dust extractor within 5m of the tools to
which it will be connected.
2. Connect up to three tools to the extractor inlet (E)
using a 100mm Ø hose (not supplied).
Important: If fewer than three tools are connected,
place the inlet caps supplied over the unused holes
of the extractor inlet.
3. Check that the collection bags (D) and lter bags (F)
are securely attached and not overlled or clogged.
4. Check that any suction hoses attached to the
extractor inlet (E) are securely clamped in place.
5. Connect the mains power cable to a power supply.
8.2 No-Volt On/O Switch
The dust extractor is equipped with a no-volt on/o
switch (2) (Fig. 13).
In the event of a power supply disruption, the machine
will require manually restarting once power has been
returned.
• To switch the extractor on, open the yellow switch
cover and press the GREEN ( | ) button.
• To switch the extractor o, open the yellow switch
cover and press the RED () button.
Important: ALWAYS switch o the machine using the
no-volt switch. NEVER use the mains power switch to
turn o the machine. ALWAYS keep the switch covered
when the product is not in use.
8.3 Emptying the Collection Bags
The collection bags (D) should be emptied as they
approach capacity.
Important: DO NOT allow the collection bags to become
completely full as this may cause blockages in the
collection bag ducts (C) and motor (K).
To empty or replace the collection bags:
1. Gently tap around the collection bag duct to release
any dust that has settled inside it.
2. Release the clamp on the strap (L) around the top of
the collection bag, unhook the spring and loosen the
strap.
3. Carefully slide the bag away from the collection bag
duct and dispose of the dust content.
Important: Recycle or dispose of any dust waste in
accordance with local regulations.
4. Replace the bag and reattach the strap to secure it in
place.
Important: This machine is not suitable for ne or
hazardous dust such as medium density breboard
(MDF).
(2)

Bekijk gratis de handleiding van Draper 80947, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkDraper
Model80947
CategorieStofzuiger
TaalNederlands
Grootte3007 MB