Draper 28814 handleiding
Handleiding
Je bekijkt pagina 12 van 20
– 12 –
8. PREPARATION
8.3 GROUNDING CONNECTION –
FIG. 5
WARNING! Before using this equipment you
must provide a ground connection to the
inverter.
On the casing of the inverter is an earthing terminal
(14). This earthing terminal is connected to the
case of the inverter and also to the earth terminal
of the AC output socket. The use of this earthing
terminal will depend on your particular installation.
In any installation, heavy duty, green+yellow-
insulated wire should be used for this connection.
In a stationary land based installation, the earth
terminal should be connected to a metal earthing
stake driven into the ground to a depth of 1.2M or
more, If the battery system powering the inverter
does not have a connection to ground, one of the
battery terminals (commonly the negative terminal)
should also be connected to the earthing stake.
In a vehicle where the inverter is wired directly to
the battery, the earth terminal is simply connected
to the vehicle chassis. If the inverter is to be used
in a vehicle on a temporary basis and will be
powered via the cigarette lighter socket in the
vehicle, the earth terminal should be connected via
a short link to either the negative or positive DC
input terminal of the inverter, depending on whether the vehicle has a negative or positive chassis
connection. However, when using the inverter to power equipment used outside the vehicle, an
earthing stake should also be used, as described above.
In a boat, the grounding terminal should be connected to the existing grounding system, which
may be the hull of the craft, or a network of ground wires.
Note: The grounding terminal of the AC outlet is connected to the neutral terminal. This is the
same as a standard household power point where the neutral line is bonded to grounding and
there is normally no voltage between them.
8.4 CHASSIS EARTHING
The chassis earthing lug should be connected to an earthing point, which will vary depending
on where the power inverter is installed. In a vehicle, connect the chassis ground lug to the
chassis of the vehicle. In a boat, connect to the boat’s grounding system. In a fixed location,
connect to grounding.
5 FIG.
(14)
(14)
Bekijk gratis de handleiding van Draper 28814, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | 28814 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2902 MB |
