Draper 20129 handleiding
Handleiding
Je bekijkt pagina 9 van 14
Important: Read all the safety instructions before
attempting to assemble this product. Loosely secure all
xings during assembly and tighten once complete. Do
not overtighten joints and xings.
WARNING! The parts of this product are heavy. Seek
assistance when assembling the stand and do not
over-exert yourself.
1. Attach the rear crossbar (B) to the support column
assembly (A) and central arm (D):
a. Position the central arm so that the horizontal part
of the bracket is level with the top edge and feed
the square end into the square socket of the
central support arm.
b. Position the rear crossbar with the axles on the
lower edge and align it with the central support
column.
c. Pass an M12 x 80mm bolt (J) through an M12
spring washer (N), up through the base of the rear
crossbar and into the support column assembly,
tightening it to secure.
2. Attach the front crossbar (C) to the central arm:
a. Pass two M12 x 80mm bolts (J) through the front
crossbar and the central arm bracket.
b. Add an M12 washer (M) and an M12 spring washer
(N) to each bolt and tighten with an M12 nut (O).
3. Attach the front casters (E):
a. Pass the front caster bolts up through the base of
the front crossbar.
b. Add an M12 spring washer (N) to each bolt and
tighten with an M12 nut (O).
4. Place a rear wheel (F) onto each axle of the rear
crossbar and secure in place with an M14 washer (L)
and split pin (Q).
Important: The rear wheels should be positioned so
that the deeper wheel hub is facing inwards.
5. Attach the mounting plate (G):
a. Slide the mounting plate through the support
column socket so that the plate is positioned above
the central arm.
b. Pass the mounting plate handle (H) through the
opening in the mounting plate stem.
c. Insert the locking pin (P) to secure the mounting
plate in position.
d. Pass four M12 x 50mm bolts (K) through the back
of the mounting plate and attach a mounting arm
(I) to each.
e. Secure each mounting arm in place with an M12
washer (M), an M12 spring washer (N) and an M12
nut (O).
6. Check that the stand frame is not twisted and that all
four wheels are touching the ground, then tighten all
attachments.
7. Assembly Instructions
– 9 –
EN
Bekijk gratis de handleiding van Draper 20129, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Draper |
| Model | 20129 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1114 MB |
