Dometic FT7000P handleiding
Handleiding
Je bekijkt pagina 7 van 16
7
EN
Pro-Pedal Foot Throttle Installation
4.2.2 Measuring Cable Routing for an
Inboard or I/O Engine
q
w
6 Cable Routing for an Inboard or I/O Engine
q
Engine Control
Connection
w
Throttle Connection
1. Measure from the engine control connection
along an unobstructed cable routing to the throttle
connection.
2. Round the resulting measurement up to the nearest
whole foot.
3. Use this measurement to obtain the correct length
cables.
I
The last two digits of a Dometic cable part number
equals the length of the cable in feet.
4.3 Preparing the Mounting
Location
This section describes how to plan and prepare the
engine control mounting location.
4.3.1 Planning the Mounting Location
I
To ensure the best performance, the free operation
of the pedal and all its connections is essential.
Consider the following when planning where to mount
the engine control:
• Allow adequate clearance for the full range of pedal
movement at any position on the slide mount (if one
is used) and for the operator to comfortably position
their leg.
• Allow adequate clearance under the deck for the
cable.
• Allow a minimum of 36 in. (914 mm) from the cable
nest connection with no restraint.
4.3.2 Preparing the Mounting Opening
I
If replacing an engine control, refer to the
manufacturer’s instructions for removing the
existing engine control, then compare the
mounting template to the existing opening and
modify as required.
Use the mounting template to cut and drill the required
mounting openings. See “Mounting Template” on
page15.
5 Installation
I
Refer to the manufacturer’s instructions for cable
direction, adjustments, and lubrication.
This section describes how to install the cable and
mount the engine control.
5.1 Connecting the Cable to the
Engine Control
I
Push and pull refer to the direction of the cable
motion to open the throttle.
1. Determine where to connect the cable to the throttle
wheel according to the cable entry direction.
– For rear entry cable connections, see Figure 7.
– For top entry cable connections, see Figure 8.
– For front entry cable connections, see Figure 9.
Bekijk gratis de handleiding van Dometic FT7000P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dometic |
| Model | FT7000P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1992 MB |
