Dometic FT7000P handleiding
Handleiding
Je bekijkt pagina 6 van 16
6
EN
Preinstallation Pro-Pedal Foot Throttle
4 Preinstallation
WARNING: ELECTRIC SHOCK HAZARD.
Failure to obey these warnings could result in
death or serious injury.
• Disconnect the power before performing any
installation or maintenance activities.
• Before cutting or drilling, check under the deck
and make sure there is sufficient clearance and
space around any wires, tubes, pipes, and other
obstructions.
This section describes the activities to complete prior to
installing the engine control.
4.1 Planning the Cable Routing
I
Dometic Xtreme
TM
cables are recommended,
however the engine control is compatible with
many current 3300/33C, OEM cables.
Consider the following when planning where to route
the cable:
Cable Placement
• Do not install the cable in areas of excess heat
such as on, or close to, exhaust manifolds where
temperatures may exceed 212°F (100°C).
• Do not rest the cable on sharp edges that could
cause chafing.
Bend Radius
• When routing the cable, select a path with a
minimum number of bends, making the bends as
large as possible.
• Sharp or frequent bends will result in difficult throttle
control, loss of motion, and premature cable wear.
• Do not make bends of less than the recommended
minimum bend radius.
Cable Type
Minimum Bend
Radius
Dometic Xtreme, 3300/33C, OEM 4 in. (10 cm)
Standard 3300/33C, OEM 8 in. (20 cm)
Supporting the Cable
• Do not bundle the cable together with electrical
wiring.
• Do not tie or clamp the cable within 36 in. (91 cm) of
the engine control.
• When supporting the cable beyond 36 in. (91 cm)
of the engine control, the cable should be loosely
clamped or tied for support at regular intervals.
4.2 Determining the Cable Length
One cable is required to install the engine control. To
determine which length cable to use, measure the cable
routing path appropriate to the engine type.
4.2.1 Measuring the Cable Routing for an
Outboard Engine
q
w
5 Cable Routing for an Outboard Engine
q
Engine Control
Connection
w
Outboard Engine
1. Measure from the engine control connection along
an unobstructed cable routing to the center of the
outboard engine.
2. Add 4 to the measurement to allow for a loop to
provide unrestricted engine movement.
3. Round the resulting measurement up to the nearest
whole foot.
4. Use this measurement to obtain the correct length
cable.
I
The last two digits of a Dometic cable part number
equals the length of the cable in feet.
Bekijk gratis de handleiding van Dometic FT7000P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dometic |
| Model | FT7000P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1992 MB |
