Dito Sama 602314 handleiding

Handleiding

12345678910111213141516171819202122/ 22

Afdrukken

Je bekijkt pagina 8 van 22

8

2. TRANSPORT, HANDLING AND STORAGE

2.1. INTRODUCTION

Transport (i.e. transfer of the machine from one place to another) and handling (i.e. transfer inside

workplaces) must occur with the use of special and adequate means.

ATTENTION!

Given their size, the machines can be stacked on top of each other during trans-

port, handling and storage by complying with that specied on the slip placed on the

packing;

The machine must only be transported, handled and stored by qualied personnel, who must:

- have specic technical training and experience in the use of lifting systems;

- have knowledge of the safety regulations and applicable laws in the relevant sector;

- have knowledge of the general safety rules;

- ensure the use of personal protection equipment suitable for the type of operation carried out;

- be able to recognise and avoid any possible hazard.

2.2. TRANSPORT: INSTRUCTIONS FOR THE CARRIER

ATTENTION!

Do not stand under suspended loads during loading/unloading operations. Unautho-

rised personnel must not enter the work area.

ATTENTION!

The machine’s weight alone is not su󰀩cient to keep it steady. The transported load can

shift:

- when braking;

- when accelerating;

- in corners;

- on rough roads.

2.3. HANDLING

Arrange a suitable area with at oor for machine unloading and storage operations.

2.4. PROCEDURES FOR HANDLING OPERATIONS

For correct and safe lifting operations:

• use the type of equipment most suitable for characteristics and capacity (e.g. electric pallet truck or

lift truck);

• cover sharp edges;

Before lifting:

• send all operators to a safe position and prevent persons from entering the handling area;

• make sure the load is stable;

• make sure no material can fall during lifting. Manoeuvre vertically in order to avoid impacts;

• handle the machine, keeping it at minimum height from the ground.

ATTENTION!

For machine lifting, do not use movable or weak parts such as: casings, electrical

raceways, pneumatic parts, etc.

2.5. TRANSLATION

The operator must:

• have a general view of the path to be followed;

• stop the manoeuvre in case of hazardous situations.

12345678910111213141516171819202122/ 22

Bekijk gratis de handleiding van Dito Sama 602314, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Wasmachine