Dito Sama 602285 handleiding
Handleiding
Je bekijkt pagina 28 van 31
SPIRAL MACHINE
L10 / L22 / L33 / L42 / L53 / L62
pag. 30
PERSONNEL WHO WILL REASSEMBLE THEM IN THE ORIGINAL POSITION AS
SOON AS THE MAINTENANCE OPERATIONS ARE COMPLETE: AT THE END OF
THE MAINTENANCE IT IS NECESSARY TO VERIFY THAT THE PROTECTIONS
ARE CORRECTLY ASSEMBLED AND EFFICIENT. THE MACHINE CANNOT BE
STARTED AFTER A MAINTENANCE INTERVENTION WITHOUT THE
PROTECTIONS AND OTHER DEVICES HAVING BEEN REASSEMBLED.
8.3 Procedures for putting into maintenance status
Proceed as follows:
1. Follow the instructions in the paragraph 6.5.
2. Enclose the machine and affix the "MACHINE UNDER MAINTENANCE" sign.
8.4 Periodic maintenance
8.4.1 Daily checks
EACH start of shift.
1. Efficiency control of the microswitch connected to the movable guard of the bowl.
2. Control operation of the control panel (see paragraph 5.1).
3. Clean the machine as described in the paragraph 8.4.4.
4. Checking the efficiency of the proximity sensor between the bowl and the machine frame.
8.4.2 Monthly checks
At least ONCE A MONTH:
1. Check the tension of the upper chain located inside the machine head which must be adjusted when
there is a slowdown in the rotation of the spiral or if the rotation movement is not fluid during the
execution of a processing cycle by loosening the screws and removing the upper fixed guard. At this
point it is necessary to loosen the screws that fix the spiral support by a few turns and to pull the spiral
until the chain tension is optimised. Finally lock the spiral support by tightening the screws and
reassembling the fixed guard.
At least ONCE EVERY 6 MONTHS:
1. Grease the chains located inside the head and inside the base of the machine by loosening the screws
that lock the fixed guard to protect the head and the fixed guard located behind the machine; deposit
within the chains a reasonable amount of suitable and sufficient grease to ensure the lubrication of all
the links of the chains; when the operation is completed, reassemble the two fixed guards.
ATTENTION
CHAIN LUBRIFICATION MUST BE PERFORMED BY A SPECIALIZED TECHNICIAN
TRAINED BY THE MANUFACTURER
Bekijk gratis de handleiding van Dito Sama 602285, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dito Sama |
| Model | 602285 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3724 MB |
