Dito Sama 602284 handleiding
Handleiding
Je bekijkt pagina 18 van 31
SPIRAL MACHINE
L10 / L22 / L33 / L42 / L53 / L62
pag. 20
4.4 Positioning
The machine must be handled as indicated in the paragraph 4.3
When positioning the machine, check:
• that the floor is smooth, flat and resistant enough to allow the machine to rest safely;
• using a centesimal levelling device, check that the machine is level;
• that there is sufficient space around the machine to comply with the minimum recommended distance of
800 mm from the surrounding walls;
• that the machine is positioned near an adequate power supply;
• that the operator can easily load the ingredients and remove the mixture;
• that there is sufficient space around the machine for easy cleaning and maintenance;
• that the two front wheels are locked by the mechanical brake device.
4.5 Wiring and connection
4.5.1 Connection to the electrical power supply
Refer to the technical data shown in the paragraph 3.2 for connecting of the machine to the power supply.
Connection of the machine to the electrical network must be carried out by specialist personnel, in
compliance with the good technical and safety standards in force.
It is essential to connect the machine to an efficient and controlled earthing network.
If in doubt about the efficiency of the network, do not connect the machine.
The user is required to provide an adequate disconnector for the power line upstream of the machine, as
well as effective means of protection against overcurrents and indirect contacts.
Effective means of protection against overcurrents can be represented by:
• fuses,
• automatic switches,
• magnetothermic switches.
Effective means of protection against direct contacts, instead, can be represented by:
• differential switches,
• fault sensors.
When connecting, check:
• that the voltage of the power supply corresponds to the voltage and frequency indicated in the wiring
diagram annexed to the machine (an incorrect supply voltage can damage the machine);
• that the power supply network is equipped with an adequate earthing system;
• the power supply network must have a system impedance lower than 0.224Ohm, in accordance with
standard IEC 61000-3-11:2017
• the correct position and fixing of the microswitches;
• that the direction of rotation of the bowl is correct, i.e. clockwise seen from above (as indicated on the
label applied on the bowl). If the direction of rotation of the bowl is not correct, it is necessary to invert
the two wires of the power supply cable on the electrical box of the machine in order to correct the
direction of rotation.
ATTENTION
IF THE POWER CABLE IS DAMAGED, IT MUST BE REPLACED BY THE
MANUFACTURER, A TECHNICIAN, OR QUALIFIED PERSONNEL TO AVOID
HAZARDS.
Bekijk gratis de handleiding van Dito Sama 602284, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Dito Sama |
| Model | 602284 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3724 MB |
